It focuses solely on the adequacy of these transfer surface dimensions for a static seating surface....
Search Results "Dispersed Seating"
-
Conclusions
-
4.1.2 Surface Design of Examination Tables and Chairs
Instead, they are contoured, such as by using bolsters along the perimeters, to provide greater security once patients are lying or seated on the table or chair....
-
Transit Shelters (R308.2) (Section-by-Section Analysis)
Where seating is provided within transit shelters, the clear space must be located either at the end of a seat, or not overlap the area within 460 millimeters (1.5 feet) from the front edge...
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
., toilet seats, shower seats, dressing benches).”6 In addition, the Access Board recommended, “Where patient support surfaces are contoured or upholstered for patient comfort or to support...
-
1009.4.2 Area of refuge
Areas of refuge are not required at elevators serving smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
-
§382.113(b)
(b) Assistance within the restroom or assistance at the passenger's seat with elimination functions; and...
-
§382.27(c)(4)
(4) Transportation for an electric wheelchair on an aircraft with fewer than 60 seats;...
-
Food and Restaurant Services
Some accessible tables must be provided and must be dispersed throughout the dining area rather than clustered in a single location....
-
Guest Rooms with Communication Features
Commenters suggested that the requirements for scoping and dispersion of guest rooms for persons with mobility impairments and guest rooms with communication features are too complex for...
-
§382.85(a)
(a) As a carrier that assigns seats in advance, you must provide accommodations in the following ways:...
-
§ 36.406(f)(4)(i)
(i) It is located within the rear sixty percent (60%) of the seats provided in an auditorium; or...
-
§ 35.151(g)(4)(i)
(i) It is located within the rear sixty percent (60%) of the seats provided in an auditorium; or...
-
20. DESIGN AND CONSTRUCTION STANDARDS
for review and approval a web-based design guide that identifies the ADA Standards requirements for: (1) registration and other service counters; (2) accessible guest room numbers and dispersion...
-
505.10 Handrail Extensions
In assembly areas, extensions shall not be required for ramp handrails in aisles serving seating where the handrails are discontinuous to provide access to seating and to permit crossovers...
-
505.10 Handrail Extensions
In assembly areas, extensions shall not be required for ramp handrails in aisles serving seating where the handrails are discontinuous to provide access to seating and to permit crossovers...
-
505.10 Handrail Extensions
In assembly areas, extensions shall not be required for ramp handrails in aisles serving seating where the handrails are discontinuous to provide access to seating and to permit crossovers...
-
NOTES
See Analysis of Seat Heights for Wheeled Mobility Devices at: http://udeworld.com/analysis-of-seat-height-for-wheeled-mobility-devices. ...
-
11B-704.4.1 Height
Exception: Where seats are provided, TTYs shall not be required to comply with Section 11B-704.4.1. [2010 ADAS] Advisory 704.4.1 Height. ...
-
§ 37.167(j)(1)(ii)
(ii) Individuals sitting in or a fold-down or other movable seat in a wheelchair securement location....
-
Notes
Seat heights for males were typically higher than for females....
-
§382.81(b)
(b) You must provide an adjoining seat for a person assisting a passenger with a disability in the following circumstances:...
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
11B-903.7 Wet locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....