Vertical alignment may be accomplished by vehicle air suspension or other suitable means of meeting the requirement....
Search Results "Vertical Reference Plane"
Filters
Commonly Searched Documents
-
§ 38.173(b)
-
Harmar CPL400P Portable Vertical Platform Lift
Harmar's Portable Package is the perfect solution for those that want the versatility and convenience to use a lift when and where they need it. A great solution for schools,...
-
Alterations [4.1.6(1)(f) & (k)]
For those not exempt, ADAAG provides guidance on the type of alterations that may require vertical access between floors: major structural modifications resulting from replacement or addition...
-
T502.2.1 Over-the-Road Buses
For over-the-road buses, the vertical clearance at doorways shall be 65 inches (1650 mm) minimum....
-
11B-204.1 General
Within play areas, protruding objects on circulation paths shall not be required to comply with Section 11B-307 provided that ground level accessible routes provide vertical clearance in...
-
Figure 609.3 Spacing of Grab Bars – Drawing from the U.S. Access Board
-
1016.8.4 Turning Space
Vertical alignment between the outdoor recreation access route, turning space, and resting interval shall be nominally planar....
-
1016.8.4 Turning Space
Vertical alignment between the outdoor recreation access route, turning space, and resting interval shall be nominally planar....
-
§ 38.125(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station platform to ramp may be vertical...
-
Other Requirements [4.11.2]
The ASME code provides specifications for vertical wheelchair lifts and inclined wheelchair lifts....
-
410.1 General
Platform lifts shall comply with ASME A18.1 (1999 edition or 2003 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
6.9
OR b. the measurement of the vertical viewing angle (the angle between a horizontal line from the eye to the screen and a line from the eye to the top of the screen) are within the range...
-
Sec.36.308(a)(1)(ii)(A)
(A) Are dispersed throughout the seating area;
-
4.11.3 Entrance
If platform lifts are used then they shall facilitate unassisted entry, operation, and exit from the lift in compliance with 4.11.2.
-
4.11.3 ENTRANCE
If platform lifts are used, then they should facilitate unassisted entry and exit from the lift in compliance with 4.11.2.
-
4.1.6(1)(f)
(f) If an escalator or stair is planned or installed where none existed previously and major structural modifications are necessary for such installation, then a means of accessible vertical...
-
Harmar TG400 Toe Guard Commercial Platform Lift
Free-standing Toe guard VPL with stationary lower landing walls and gate shields the lift inside. As a self-contained unit, Toe Guard requires minimal construction and is ADA...
-
Harmar CPL800H-1400H Hydraulic CPL with Modular Tower
Easy-install modular panels adapt 4' to 14' lifting height. Amazingly quiet and smooth hydraulic operation. Upper frame can be assembled from within the hoistway, with the...
-
T502.2 Doorways with Lifts, Ramps or Bridgeplates
The vertical clearance at doorways with lifts, ramps or bridgeplates shall comply with T502.2....
-
4.1.6(1)(b)
(b) If power-driven vertical access equipment (e.g., escalator) is planned or installed where none existed previously, or if new stairs (other than stairs installed to meet emergency exit...
-
A4.1.3(5)
If a building is exempt from the elevator requirement, it is not necessary to provide a platform lift or other means of vertical access in lieu of an elevator....
-
Accessible Passenger Loading Zones [§503]
Accessible Passenger Loading Zones [§503] Requirements for accessible passenger loading zones address vehicle pull-up spaces and access aisles, including their dimensions, surfacing, and vertical...
-
609.3 Spacing
The space between the wall and the grab bar shall be 1½ inches (38 mm). The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm)...
-
609.3 Spacing
The space between the wall and the grab bar shall be 1 1/2 inches (38 mm). The space between the grab bar and projecting objects below and at the ends shall be 1 1/2 inches (38 mm)...
