Trail Constructed Feature—A constructed feature that functions as part of the trail tread. Examples include puncheon, trail bridges, boardwalks, waterbars, and switchbacks....
Search Results "Tread Depth"
-
Trail Constructed Feature
-
7.4.5 Passing Spaces
Trails with a clear tread width less than 60 inches (1525 mm) shall provide passing spaces complying with 7.4.5 at intervals of 1000 feet (300 m) maximum. ...
-
7.4.4 Resting Intervals
Resting intervals shall comply with 7.4.4. Where the trail grade exceeds 1:20 (5 percent), resting intervals shall be provided as specified in Table 7.4.3.1.
-
1017.6 Openings
This section requires openings in the surface of trails, passing spaces, and resting intervals such as spaces between the boards in a boardwalk to not allow passage of a sphere more...
-
7.2.2.1 Determining Impracticability
The use of General Exception 2 is reasonable where one or more conditions for an exemption in section 7.1 and at least one of the following limiting factors exist: Limiting Factor...
-
H16
[ADA Standards § 4.17.3] Yes No If No, note the width and depth of the stall. _________________...
-
4.34.3(2)(a) Reach Depth Not More Than 10 in
(a) Reach Depth Not More Than 10 in (255 mm)....
-
7.4.7 Openings
Openings in trail tread surfaces, trail resting spaces, and trail passing spaces shall be small enough to prevent passage of a 1/2 inch- (13 mm-) diameter sphere....
-
407.12.2.1 Unobstructed Side Reach (Section-by-Section Analysis)
Although existing 508 Standards § 1194.25 (j)(2) permits a maximum reach height of 54 inches, it contains the same minimum height (15 inches) and 10-inch reach depth....
-
Obstacles [1018.5]
Changes in the vertical alignment of boards or the connection points for removable sections of beach access routes can be obstacles to beach access. When beach access routes are...
-
1018.5 Obstacles
This section contains technical requirements for obstacles on beach access routes and resting intervals. The vertical alignment of boards on a beach access route or removable...
-
Surfaces of Trails
Trail surfaces must be firm and stable. The first general exception allows achieving firmness and stability to the extent practicable if a condition for an exception prohibits full...
-
4.34.3(2)(b) Reach Depth More Than 10 in
(b) Reach Depth More Than 10 in (255 mm)....
-
Side Reach [§308.3]
The maximum reach depth for this range is 10” measured from the available clear floor space....
-
Maximum side reach ranges. (Section-by-Section Analysis)
Reach ranges apply to a variety of building elements, including light switches, key pads, electrical outlets, fire alarm pulls, card readers, thermostats, elevator controls, pay...
-
G. Compartment Size
G. If the accessible toilet is in a stall, does the stall measure at least 60" wide and 56" deep if it is wall mounted or 59" deep if it is floor mounted to allow persons who use...
-
Side Approach and Reach
[See subsections ...]
-
Obstructed High Reach
The maximum high reach is reduced to 46” when the reach over an obstruction is deeper than 10” (to a maximum of 24”). Obstructions at side reaches are limited to a height of...
-
Using the ORAR Exceptions [F202.3, Exception 4 and 1016, Exceptions 1, 2, and 3]
Where elements or spaces in camping and picnic facilities, viewing areas, or trailheads are altered but the circulation path to the altered element or space is not changed, the...
-
2.10.1 Clear Width
Gate openings and openings in barriers for pedestrian passage shall provide a clear width of 36 inches (915 mm), complying with ODAAG, section 1017.3 Clear Tread Width....
-
904.4 Sales and Service Counters
The accessible portion of the counter top shall extend the same depth as the sales or service counter top....
-
11B-904.4 Sales and service counters
The accessible portion of the counter top shall extend the same depth as the sales or service counter top....
-
11B-904.4 Sales and service counters
The accessible portion of the counter top shall extend the same depth as the sales or service counter top....
-
904.4 Sales and Service Counters
The accessible portion of the counter top shall extend the same depth as the sales or service counter top....