[See subsections ...]
Search Results "RERC Rec-Tech: Rehabilitation Engineering Research Center on Recreational Technologies"
Filters
Commonly Searched Documents
-
DIVISION 10: RECREATION FACILITIES
-
Summary analysis of wheelbase measurements on wheeled mobility devices
IDeA Center, University at Buffalo Date: 3/20/2013 From: Clive D’Souza and Edward Steinfeld, IDeA Center, University at Buffalo To: Marsha Mazz, U.S....
-
[2010 ADAS] 105.2.2 ASME
ASME American Society of Mechanical Engineers Three Park Avenue New York, NY 10016-5990 Standard Reference Number Title Referenced in code section...
-
Summary of Results
However, recommendations for future study call for a cost comparison of aggregate versus soil stabilizer trail surface materials, therefore depending on the results of future research, the...
-
III. Results of the Study
Prospective participants were asked to answer questions pertaining to inclusion criteria set by the researchers and the funding agencies–whether the trail was predominately pedestrian/hiker...
-
3.1.1.3 Recreational Vehicle Parking Areas
Where recreational vehicle (RV) parking areas are provided at a camping facility or dump station, parking areas shall be provided for accessible RVs and trailers in accordance with Table...
-
12181(7)(D)
(D) an auditorium, convention center, lecture hall, or other place of public gathering;...
-
Buildings in Recreation Sites
Permanent buildings with walls, roof, and a door at recreation areas must meet all the applicable provisions of ABAAS, as well as those of other applicable building codes....
-
Trace Research & Development Center
The Trace Research & Development Center is a part of the College of Information Studies at the University of Maryland....
-
Prevalence and Incidence of Low Vision and Blindness in the U.S.
Okay, so how much is out there if we’re using these definitions of low vision? What’s the prevalence and incidence of low vision? Well, there have been a lot of numbers thrown...
-
Assumptions
Assumptions In 2007 the U.S. Access Board published values for firmness and stability in the NPRM for Outdoor Developed Areas based on use of the Rotational Penetrometer. For the...
-
Anthropometry for Persons with Disabilities: Needs for the 21st Century
[See subsections ...]
-
Experiences at museums and parks
Experiences at museums and parks Several themes emerged from a discussion of participant’s best and worst museum and park visits:
-
3. Study Findings
[See subsections ...]
-
Accessible Exterior Surfaces
Accessible Exterior Surfaces This is an executive summary of the “Accessible Exterior Surfaces Technical Report” dated 24 April 1999. This report is available through the Access...
-
RECOMMENDATIONS
RECOMMENDATIONS An objective test procedure for measuring the firmness and stability of surfaces with a portable device and performance specifications need to be accepted in order...
-
Qualitative Analysis by Surface Type
Qualitative Analysis by Surface Type The observational data collected through the visual inspections of the sites and discussions with the playground owners provided invaluable...
-
Part I. A Longitudinal Study of Trail Surfaces Final Report
Part I. A Longitudinal Study of Trail Surfaces Final Report
-
Instrumentation for Analysis
Instrumentation for Analysis One instrument, the Rotational Penetrometer (Figure A), was used for data collection. An on-site inspection form (Appendix C) was created to collect...
-
Part II. National Trail Surface Survey Final Report
Part II. National Trail Surface Survey Final Report
-
Moisture and Durability
Moisture and Durability Due to the in-situ nature of this testing and the size of the test surfaces, we did not have a means for non-destructively evaluating moisture or...
-
C102.3 American National Standards Institute/ Institute of Electrical and Electronics Engineers (ANSI/IEEE)
Copies of the referenced standard may be obtained from the Institute of Electrical and Electronics Engineers, 10662 Los Vaqueros Circle, P.O....
-
E102.3 American National Standards Institute/ Institute of Electrical and Electronics Engineers (ANSI/IEEE)
Copies of the referenced standard may be obtained from the Institute of Electrical and Electronics Engineers, 10662 Los Vaqueros Circle, P.O....
-
Comparison: 2010 and 1991 ADA Standards for Accessible Design - Scoping Requirements
If you have corrections or additions to these documents please send an email to: ADAinfo@NewEnglandADA.org Prepared by: New England ADA Center A project of the Institute for Human...
