than one assembly area and the assembly areas required to provide assistive listening systems are under one management, the total number of required receivers shall be permitted to be calculated...
Search Results "Photometric Calculation"
Filters
Commonly Searched Documents
-
F219.3 Receivers
-
TEST NO. 2 – SITE ANALYSIS TEST
Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope....
-
219.3 Receivers
than one assembly area and the assembly areas required to provide assistive listening systems are under one management, the total number of required receivers shall be permitted to be calculated...
-
DOT Response
These statistics should be calculated on the same basis nationwide, in order to permit better program evaluation and comparisons across transit providers....
-
Scoping [4.1.2(5)]
On sites with multiple lots, this number is still calculated lot-by-lot, even where accessible spaces required for one lot are located in another....
-
RESULTS OF OBJECTIVE SURFACE MEASUREMENT
It is calculated by dividing the standard deviation of the observations by the square root of the number of observations. Figure 3. Wheelchair Work Values for Turning...
-
Signal Clearance Intervals
Additionally, the AASHTO calculated values (assuming acceleration rates of 1.2 m/sec2 (4 ft/sec2)) are shown....
-
Addendum E: Comparison of participants tested at the National Disabled Veterans Winter Sports Clinic (NDVWSC) compared to the participants tested at the Human Engineering Research Laboratories and Hiram G. Andrews Center
Other 6 2 For protocols A, B and C (same set up as described in the report) a comparison of the 5th, 25th, 50th, 75th, and 95th percentiles was calculated...
-
1. Sloped Surfaces
When the distance is more than two inches, record the distance on the checklist so the exact slope can be calculated later....
-
219.3 Receivers
than one assembly area and the assembly areas required to provide assistive listening systems are under one management, the total number of required receivers shall be permitted to be calculated...
-
1.1.4 Walk cross slope
Calculate the cross slope at these locations using the horizontal walking surface width and difference between the measurement elevations at the edges of the walking surface (i.e. the rise...
-
IDEA Center
Occupied length of devices was calculated by computing the dimension from the extreme rear and forward points on the body or chair....
-
3.2. Baselines
This section also provides an overview of how the Low Accessibility, Medium Accessibility, and High Accessibility baselines are calculated. ...
-
3.0 Comparison of Research Methodologies
Parallax was corrected during the calculation of the dimensions....
-
6.3. Auditoriums Exhibiting Analog Movies
The methodology for calculating the costs for auditoriums exhibiting analog movies is identical to that of auditoriums exhibiting digital movies. ...
-
11B-219.3 Receivers
than one assembly area and the assembly areas required to provide assistive listening systems are under one management, the total number of required receivers shall be permitted to be calculated...
-
Addendum F: Relative Height Differences
Relative heights were calculated for high and low transfers for all three protocols. Refer to Addendum A for the definition of relative height....
-
Taking Measurements
When the distance is greater than 2 inches, record the distance on the checklist so the exact slope may be calculated later if needed....
-
3.2.2.2. Medium Accessibility Baseline
The Medium Accessibility baseline is calculated by dividing the number of auditoriums equipped to provide closed movie captioning or audio description, as reported in the 2015 survey, by...
-
Station 3-Turning Radii
The data entry spreadsheet was set up to calculate the average speeds, based on these recorded times, as participants traveled through each radius. 2. ...
-
Path Width
AASHTO (pp. 35-36) recommends a minimum path width of 3 m (10 ft), notwithstanding the procedures given in the Highway Capacity Manual for calculating the number and effects of passing events...
-
11B-219.3 Receivers
than one assembly area and the assembly areas required to provide assistive listening systems are under one management, the total number of required receivers shall be permitted to be calculated...
-
11B-219.3 Receivers
than one assembly area and the assembly areas required to provide assistive listening systems are under one management, the total number of required receivers shall be permitted to be calculated...
-
Mesa Safe Company MP101 Pedestal Electronic Hotel Safe
The perfect companion for dorms and off-campus living where protection and securing your essentials such as textbooks, calculators, paperwork and other expensive items need to be locked...
