11B-810.2 Bus boarding and alighting areas

Note: This document or portion of document references a state or local code that is stricter than the 2010 ADA Standards requires.

11B-810.2 Bus boarding and alighting areas.

Bus boarding and alighting areas shall comply with Section 11B-810.2.

Advisory 11B-810.2 Bus boarding and alighting areas. At bus stops where a shelter is provided, the bus stop pad can be located either within or outside of the shelter. ◼

11B-810.2.1 Surface.

Bus stop boarding and alighting areas shall have a firm, stable surface.

Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches (1524 mm) minimum, measured parallel to the vehicle roadway.

U.S. Access Board's Note to Reader:

The Department of Transportation's ADA Standards indicate that compliance is required to the extent construction specifications are within a public entity's control:

[ADA Title II - Public Transportation] 810.2.2 Dimensions. Bus boarding and alighting areas shall provide a clear length of 96 inches (2440 mm), measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches (1525 mm), measured parallel to the vehicle roadway. Public entities shall ensure that the construction of bus boarding and alighting areas comply with 810.2.2, to the extent the construction specifications are within their control.

A plan view shows a bus pulled up to an area for passengers to board or alight. A clear area immediately outside the bus door is shown 60 inches minimum, measured parallel to the roadway and 96 inches minimum, measured perpendicular to the curb or roadway edge.

FIGURE 11B-810.2.2 DIMENSIONS OF BUS BOARDING AND ALIGHTING AREAS

11B-810.2.3 Connection.

Bus stop boarding and alighting areas shall be connected to streets, sidewalks, or pedestrian paths by an accessible route complying with Section 11B-402. Newly constructed bus stop boarding and alighting areas shall provide a detectable transition between the boarding/alighting area and the roadway; the detectable transition shall consist of a curb with the face sloped at 35 degrees maximum from vertical or detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.4.

[2010 ADA Standards] 810.2.3 Connection. Bus stop boarding and alighting areas shall be connected to streets, sidewalks, or pedestrian paths by an accessible route complying with 402.

11B-810.2.4 Slope.

Parallel to the roadway, the slope of the bus stop boarding and alighting area shall be the same as the roadway, to the maximum extent practicable. Perpendicular to the roadway, the slope of the bus stop boarding and alighting area shall not be steeper than 1:48.

[MORE INFO...]

*You must sign in to view [MORE INFO...]

Solutions

Documents

Resources

2019 California Standards for Accessible Design Guide (effective January 1, 2020 with July 1, 2021 amendments)