Hello. Please sign in!

Note: This document or portion of document references a state or local requirement that is NOT required by the 2010 ADA Standards.

11B-703.7.2.6.4 Edges and vertices on geometric symbols. Edges shall be eased or rounded at 1/16 inch (1.59 mm) minimum, or chamfered at 1/8 inch (3.2 mm) maximum. Vertices shall be radiused between 1/8 inch (3.2 mm) minimum and ¼ inch (6.4 mm) maximum.

figure 11B-703.7.2.6.4 showing rounded, eased, and chamfered edges of geometric symbols

FIGURE 11B-703.7.2.6.4
EDGES AND VERTICES ON GEOMETRIC SYMBOLS

[MORE INFO...]

*You must sign in to view [MORE INFO...]