Hello. Please sign in!

Note: This document or portion of document references a state or local code that aligns with the 2010 ADA Standards requirements.

11B-409.4 Elevator cars.

Private residence elevator cars shall comply with Section 11B-409.4.

11B-409.4.1 Inside dimensions of elevator cars.

Elevator cars shall provide a clear floor space of 36 inches (914 mm) minimum by 48 inches (1219 mm) minimum and shall comply with Section 11B-305.

11B-409.4.2 Floor surfaces.

Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303.

11B-409.4.3 Platform to hoistway clearance.

The clearance between the car platform and the edge of any landing sill shall be 1½ inch (38 mm) maximum.

11B-409.4.4 Leveling.

Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions.

11B-409.4.5 Illumination levels.

Elevator car illumination shall comply with Section 11B-407.4.5.

11B-409.4.6 Car controls.

Elevator car control buttons shall comply with Sections 11B-409.4.6, 11B-309.3, 11B-309.4, and shall be raised or flush.

11B-409.4.6.1 Size.

Control buttons shall be ¾ inch (19.1 mm) minimum in their smallest dimension.

11B-409.4.6.2 Location.

Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall.

A plan view shows an elevator with an out-swinging hoistway door. The control panel is shown on the car side wall 12 inches minimum from the front.

FIGURE 11B-409.4.6.2

LOCATION OF PRIVATE RESIDENCE ELEVATOR CONTROL PANEL

11B-409.4.7 Emergency communications.

Emergency two-way communication systems shall comply with Section 11B-409.4.7.

11B-409.4.7.1 Type.

A telephone and emergency signal device shall be provided in the car.

11B-409.4.7.2 Operable parts.

The telephone and emergency signaling device shall comply with Sections 11B-309.3 _|Operable Parts; Height|_ and 11B-309.4 _|Operation|_.

11B-409.4.7.3 Compartment.

If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309 _|Operable Parts|_.

11B-409.4.7.4 Cord.

The telephone cord shall be 29 inches (737 mm) long minimum.

[MORE INFO...]

*You must sign in to view [MORE INFO...]