Hello. Please sign in!

Note: This document or portion of document references a state or local code that aligns with the 2010 ADA Standards requirements.

11B-1009.4 Transfer walls.

Transfer walls shall comply with Section 11B-1009.4.

11B-1009.4.1 Clear deck space.

A clear deck space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer wall. Where one grab bar is provided, the clear deck space shall be centered on the grab bar. Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars.

A plan view shows clear deck space of 60 by 60 inches minimum adjacent to a transfer wall.  Figure (a) shows this space centered at one grab bar.  Figure (b) shows this space centered on the clearance between two grab bars.

FIGURE 11B-1009.4.1

CLEAR DECK SPACE AT TRANSFER WALLS

11B-1009.4.2 Height.

The height of the transfer wall shall be 16 inches (406 mm) minimum and 19 inches (483 mm) maximum measured from the deck.

An elevation drawing shows the height of a transfer wall as 16 to 19 inches measured from the deck.

FIGURE 11B-1009.4.2

TRANSFER WALL HEIGHT

11B-1009.4.3 Wall depth and length.

The depth of the transfer wall shall be 12 inches (305 mm) minimum and 16 inches (406 mm) maximum. The length of the transfer wall shall be 60 inches (1524 mm) minimum and shall be centered on the clear deck space.

A plan view shows a transfer wall with a depth of 12 to 16 inches and a length of 60 inches minimum.

FIGURE 11B-1009.4.3

DEPTH AND LENGTH OF TRANSFER WALLS

11B-1009.4.4 Surface.

Surfaces of transfer walls shall not be sharp and shall have rounded edges.

11B-1009.4.5 Grab bars.

At least one grab bar complying with Section 11B-609 shall be provided on the transfer wall. Grab bars shall be perpendicular to the pool wall and shall extend the full depth of the transfer wall. The top of the gripping surface shall be 4 inches (102 mm) minimum and 6 inches (152 mm) maximum above transfer walls. Where one grab bar is provided, clearance shall be 24 inches (610 mm) minimum on both sides of the grab bar. Where two grab bars are provided, clearance between grab bars shall be 24 inches (610 mm) minimum.

Exception:  Grab bars on transfer walls shall not be required to comply with Section 11B-609.4.

Grab bars at transfer walls are shown perpendicular to the pool wall and extending the full depth of the transfer wall.  Figure (a) shows in plan view two grab bars with a clearance between them of 24 inches minimum.  Figure (b) shows in plan view one grab bar with a clearance of 24 inches minimum on both sides.  Figure (c) shows in side elevation a height of the grab bar gripping surface 4 to 6 inches above the wall, measured to the top of the gripping surface.

FIGURE 11B-1009.4.5

GRAB BARS FOR TRANSFER WALLS

[MORE INFO...]

*You must sign in to view [MORE INFO...]