(2) Car-borne lifts;...
Search Results "Car Lift"
-
§ 37.42(c)(2)
-
§ 38.95(b) Car lift
(b) Car Lift—...
-
§ 38.95(b)(1) Design load
The design load of the lift shall be at least 600 pounds....
-
§ 38.95(b)(2) Controls
(2) Controls—
-
§ 38.95(b)(2)(i) Requirements
The controls shall be interlocked with the car brakes, propulsion system, or door, or shall provide other appropriate mechanisms or systems, to ensure that the car cannot be moved when the...
-
§ 38.95(b)(2)(ii) Exception
Where physical or safety constraints prevent the deployment at some stops of a lift having its long dimension perpendicular to the car axis, the transportation entity may specify a lift...
-
§ 38.95(b)(2)(iii) Exception
The brake or propulsion system interlock requirement does not apply to a platform mounted or portable lift provided that a mechanical, electrical or other system operates to ensure that...
-
§ 38.95(b)(3) Emergency operation
The lift shall incorporate an emergency method of deploying, lowering to ground or platform level with a lift occupant, and raising and stowing the empty lift if the power to the lift fails...
-
§ 38.95(b)(4) Power or equipment failure
(4) Power or equipment failure. Platforms stowed in a vertical position, and deployed platforms when occupied, shall have provisions to prevent their deploying, falling, or folding...
-
§ 38.95(b)(5) Platform barriers
A movable barrier or inherent design feature shall prevent a wheelchair or mobility aid from rolling off the edge closest to the car until the lift is in its fully raised position....
-
§ 38.95(b)(6) Platform surface
The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
-
§ 38.95(b)(7) Platform gaps
Any openings between the lift platform surface and the raised barriers shall not exceed 5/8 inch wide....
-
§ 38.95(b)(8) Platform entrance ramp
(8) Platform entrance ramp. The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches,...
-
§ 38.95(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when...
-
§ 38.95(b)(10) Platform movement
No part of the platform shall move at a rate exceeding 6 inches/second during lowering and lifting an occupant, and shall not exceed 12 inches/second during deploying or stowing....
-
§ 38.95(b)(11) Boarding direction
The lift shall permit both inboard and outboard facing of wheelchairs and mobility aids....
-
§ 38.95(b)(12) Use by standees
Lifts shall accommodate persons using walkers, crutches, canes or braces or who otherwise have difficulty using steps....
-
§ 38.95(b)(13) Handrails
Platforms on lifts shall be equipped with handrails, on two sides, which move in tandem with the lift which shall be graspable and provide support to standees throughout the entire lift...
-
§ 38.125(b) Car lift
(b) Car Lift—...
-
§ 38.125(b)(1) Design load
The design load of the lift shall be at least 600 pounds....
-
§ 38.125(b)(2) Controls
(2) Controls—
-
§ 38.125(b)(2)(i) Requirements
The controls shall be interlocked with the car brakes, propulsion system, or door, or shall provide other appropriate mechanisms or systems, to ensure that the car cannot be moved when the...
-
§ 38.125(b)(2)(ii) Exception
Where physical or safety constraints prevent the deployment at some stops of a lift having its long dimension perpendicular to the car axis, the transportation entity may specify a lift...
-
§ 38.125(b)(2)(iii) Exception
The brake or propulsion system interlocks requirement does not apply to platform mounted or portable lifts provided that a mechanical, electrical or other system operates to ensure that...