A clear floor or ground space complying with Section 11B-305 shall be positioned for a parallel approach adjacent to the 36 inch (914 mm) minimum length of counter....
Search Results "Transfer Position"
Commonly Searched Documents
-
11B-904.4.1 Parallel approach
-
Eunice Noell-Waggoner, IES, LC. Value, Contrast and Reflections
A negative example is shown in slide 3, left photo; a positive example is shown in slide 3, right photo....
-
404.2.9 Door and Gate Opening Force
These forces do not apply to the force required to retract latch bolts or disengage other devices that hold the door or gate in a closed position....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
11B-904.4.1 Parallel approach
A clear floor or ground space complying with Section 11B-305 shall be positioned for a parallel approach adjacent to the 36 inch (914 mm) minimum length of counter....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar
- Hill-Rom Uno™ 102 Patient Lift
-
Recommendations
a minimum flat surface of 33 in. length for platforms accommodating wheeled mobility devices excluding scooters aids that can help wheelchair users mount the platform and position...
-
R308.1.2.1 Platform and Vehicle Floor Coordination
Boarding platforms shall be positioned to coordinate with vehicles in accordance with the applicable requirements in 49 CFR parts 37 and 38....
-
12113(c) Qualification standards and tests related to uncorrected vision
selection criteria based on an individual’s uncorrected vision unless the standard, test, or other selection criteria, as used by the covered entity, is shown to be job-related for the position...
-
404.2.7 Door and Gate Hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides....
-
404.2.7 Door and Gate Hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides....
-
Conclusion
The opinions expressed herein do not necessarily reflect the position or policy of the U.S. Department of Labor....
-
Is latch-side maneuvering clearance as specified in the Standards applicable to doors with panic bars?
Latch-side clearance not only provides proper positioning at door hardware but also facilitates proceeding through doors against the force of closers....
-
§ 38.159(b)(2)(ii) Exception
., “rotary lift”), the requirements of this paragraph (b)(2) prohibiting the lift from being stowed while occupied shall not apply if the stowed position is within the passenger compartment...
-
11B-813.2.10 Door swing
A door, in any position, shall be permitted to encroach into the turning space by 12 inches (305 mm) maximum....
-
212 and 606 Kitchens, Kitchenettes, Lavatories, and Sinks
The 1991 Standards, at section 4.24, and the 2010 Standards, at section 606, both require the clear floor space at sinks to be positioned for a forward approach and knee and toe clearance...
-
Architect
The 4040XP provides adjustments for Position 1-6, has a range of interior and exterior door sizes it can work on....
- American Standard Soltura 1 Handle Pull Down High Arc Kitchen Faucet with Soap Dispenser 9391.301
- S.R. Smith aXs Pool Lift
- Pressalit Care VALUE Support Arm Height Adjustable
-
11B-804.6.6 Refrigerator/freezer
The clear floor or ground space shall be positioned for a parallel approach to the space dedicated to a refrigerator/freezer with the centerline of the clear floor or ground space offset...
-
§382.133(f)
paragraphs (f)(1) through (7) of this section upon inquiry from an individual concerning the use in the cabin during air transportation on such a flight of a ventilator, respirator, continuous positive...