For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
Search Results "Eye Height"
Commonly Searched Documents
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
-
226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
E. Chapter 4: Boarding and Alighting
the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for maximum running slope applicable to ramps deployed to roadways or curb-height...
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
4.1.3(17)(a)
At least one public telephone per floor shall meet the requirements for a forward reach telephone3.  1 Additional public telephones may be installed at any height....
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
2.2 Key Measurement Variables and Procedures
Reaches and lifts: One-handed maximum reaches recorded at 5 different heights in three different directions for up to four different weight conditions (maximum of 60 reaches total). 4...
-
Guidelines
Tactile objects are tied closely to the exhibit’s interpretive theme and defy the same standardized approach that can be applied to an exhibit’s mounting height, door size and location,...
-
Communication Access at Doors [§806.3.2, §809.5.5]
They are more effective than locating a regular peephole at a lower height which can impact visual identification of visitors.  ...
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height. 3....
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height....
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
- Hill-Rom Unoâ„¢ 102 Patient Lift
- Da-Lite Global Product & Manufacturing Center ADA Lectern
- Whitehall Mfg. Ligature Resistant Bariatric Stainless Steel Basin
- Garaventa Elvoron CPL Vertical Platform Lift
- Sony Entertainment Access Glasses
- Boolee Voting Booth
- Whitehall Mfg. WH2142W2 Ligature-Resistant Toilet Wall Supply On-Floor Wall Waste
-
11B-502.3.3 Marking
The words "NO PARKING" shall be painted on the surface within each access aisle in white letters a minimum of 12 inches (305 mm) in height and located to be visible from the adjacent vehicular...
-
Re: When is a Curb Ramp a Ramp?
Curb height say 6'' The lowest slope for a ramp would be 5.1% or just under 1:20 So if the walkway was shorter than 10' I think it could be called a curb ramp and would only require...
- ASI Storage Solutions Plastic Cubby Shelf
-
Reach Ranges
The 1991 Standards set the maximum height for side reach at 54 inches above the floor....