Section 5 References i http://udeworld.com/analysis-of-seat-height-for-wheeled-mobility-devices ii โThe Impact of Transfer Setup on the Performance of Independentย Transfers: Final...
Search Results "Side Transfer"
Commonly Searched Documents
-
Section 5 References
-
Conclusion
Center Study at the University of Buffalo, New York: The Wheeled Mobility Anthropometry Project, Final Report, page 49, Figure 3-5, reference to โAll Device Types*โ. 3 โThe Impact of Transfer...
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
R305.2.5 Pedestrian At-Grade Rail Crossings
At pedestrian at-grade rail crossings not located within a street or highway, detectable warning surfaces shall be placed on each side of the rail crossing....
-
Surface and Size [ยง305.2 and ยง305.3]
The minimum size (30โ by 48โ) applies whether the space is positioned for forward or side approaches....
-
11B-502.6.4.1
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm)ย from the centerline of the parking space, its sides parallel to the length of the parking...
- Door King Inc. VoIP Integration for Entry and Access Control Systems
- Livescribe Echoยฎ Smartpen
-
5. Bed with clear floor space
Bed with clear floor space for a side approach next to bed....
-
Ramps
Provide handrails on each side of the ramps at the following locations:...
-
Figure M2: M301.4 Lift Compatibility
(at Diagnostic Equipment for Use by a Patient in a Supine, Prone, or Side-Lying Position)...
-
Where must curb ramps be provided?
Curb ramps must be located to ensure a person with a mobility disability can travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
Cross Slope [1017.7.2]
Cross slope is the side-to-side slope of a trail tread....
-
410.6 Doors and Gates
Side doors and gates shall provide a clear width 42 inches (1065 mm) minimum....
-
1. & 2. Sidewalk Slope
.: slopes tilting side to side) less than 1:50 (critical dimension of ยด" or less) [sic] so persons who use wheelchairs can conveniently negotiate the routes?...
-
[F] WORKSTATION
Examples include ticket booths; the employee side of grocery store check stands; the bartender area behind a bar; the employee side of snack bars, sales counters and public counters; guardhouses...
-
4.34.6.8* REFRIGERATOR/FREEZER
Provision shall be made for refrigerators which are: (1) Of the vertical side-by-side refrigerator/freezer type; or (2) Of the over-and-under type and meet the following requirements...
-
[F] WORKSTATION
Examples include ticket booths; the employee side of grocery store check stands; the bartender area behind a bar; the employee side of snack bars, sales counters and public counters; guardhouses...
-
[F] WORKSTATION
Examples include ticket booths; the employee side of grocery store check stands; the bartender area behind a bar; the employee side of snack bars, sales counters and public counters; guardhouses...
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
6. Grab Bars
Is there a horizontal grab bar at the head of the tub that is at least 12" long for stabilization and aid in transfer from a wheelchair to the fixed tub seat - see Figure 34 on page 25?...
- Zurn Industries Trap Protector
-
Top Landings
Otherwise, maneuvering at the top of ramps would require turning on the flared sides. Landings must also be as wide as the curb ramp they serve....
-
604.8.1.4 Toe Clearance
The front partition and at least one side partition shall provide a toe clearance of 9 inches (230 mm) minimum above the finish floor and 6 inches (150 mm) deep minimum beyond the compartment-side...