Tilts a full 6" (152 mm) with bottom mounted on full width stainless steel piano hinge....
Search Results "Compartment Width"
Filters
Commonly Searched Documents
-
American Specialties Adjustable Tilt Mirror 0600T
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
Where the width of the equipment is less than 36 inches wide, the proposed rule required the clearance to extend the full width of the equipment. Id....
-
c. Transfer Surface Size for Diagnostic Equipment Used by Patients in the Supine, Prone, or Side-lying Position
Commenter recommendations for transfer surface width ranged from 24 inches to 36 inches, while no commenters addressed the proposed depth of 15 inches....
-
Flush Controls on Toilets
2010 ADA Standards Flush Controls for accessible toilets are require to be on the open side of the water closet Flush Controls for accessible water closets and toilet compartments...
-
Lutron Sivoia QED Kirbé Vertical Motorized Drapery System
Depending on the width of the drapery, brackets can be selected that accept either a roller 64™ or a roller 100 shade drive. Size Tube diameter: 2.56 in....
-
382.67 What is the requirement for priority space in the cabin to store a passenger’s wheelchair?
The space must be in addition to the normal under-seat and overhead compartment storage made available for carry-on luggage....
-
Shower Spray Unit
Corresponding revisions have been made to similar requirements for shower compartments (608.6)....
-
Door and Gate Surfaces: ADA Standard Section 404.2.10
Section 404.2.10 covers the current ADA Standards for door and gate surfaces on manual doors and gates.
-
Shared Use Paths: ADA Standard Section 2.
rights-of-way guidelines, which address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-705.1.2.3 Islands or cut-through medians
Detectable warnings at pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
Openings [1016.6]
Where possible, drainage grates should be located outside the minimum clear width of the ORAR....
-
Maintaining Accessibility in Museum Shops
Museum shops must not allow merchandise to spill into aisles and narrow the width of the accessible route....
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
The diameter or width of the gripping surfaces of a handrail or grab bar shall be 1-1/4 in to 1-1/2 in (32 mm to 38 mm), or the shape shall provide an equivalent gripping surface....
-
Clearances for Side Approaches
These clearances, which are permitted to overlap, may determine the width of corridors, including entry alcoves with offset doors....
-
Seeger et al.
Both unoccupied and occupied dimensions of device width and length were measured as well as a set of other basic dimensions....
-
9.5 LOCKER ROOMS
Unobstructed aisle space in front of lockers used by handicapped people shall be a minimum of 42 in (1065 mm) clear width....
-
§ 38.159(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch (16 mm) in width....
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
III. Handrails and Stanchions
Of course, such a handrail or stanchion cannot encroach upon the required 32 inch width required for the doorway or the route leading to the clear floor space which must be at least 30 by...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
