In determining undue hardship, factors to be considered include the nature and cost of the accommodation in relation to the size, the financial resources, the nature and structure of the...
Search Results "Wheelchair Size"
-
Undue Hardship
-
7(2)(b)(vii)
(vii) Stall showers in the bathroom may be of any size or configuration. A minimum clear floor space 2'6" wide by 4'0" should be available outside the stall. (See Figure 7(d).)...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Figure 608.2.3 Alternate Roll-In Type Shower Compartment Size and Clearance ...
-
4.3.11.1(7)
) An elevator lobby when elevator shafts and adjacent lobbies are pressurized as required for smokeproof enclosures by local regulations and when complying with requirements herein for size...
-
4.5.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
11B-1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
-
11B-502.7.1 Arrangement
Accessible parking spaces located so that the accessible route passes behind parked vehicles create a safety hazard, especially for wheelchair users....
-
11B-1004.1 Clear floor space
Exercise machines and equipment shall have a clear floor space complying with Section 11B-305 positioned for transfer or for use by an individual seated in a wheelchair....
-
11B-1002.4.3 Gaps
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
-
11B-502.7.1 Arrangement
Accessible parking spaces located so that the accessible route passes behind parked vehicles create a safety hazard, especially for wheelchair users....
-
11B-1004.1 Clear floor space
Exercise machines and equipment shall have a clear floor space complying with Section 11B-305 positioned for transfer or for use by an individual seated in a wheelchair....
-
Attachment J: Access to Humboldt County Programs Housed in Others’ Facilities
Attachment J: Access to Humboldt County Programs Housed in Others’ Facilities
-
§382.67(b)
(b) If you are a carrier that uses the seat-strapping method to stow a manual passenger wheelchair, you must ensure that there is priority space for at least two such wheelchairs, if stowing...
-
Evaluation of transfers
Many studies have evaluated current accessibility guidelines in terms of space for maneuverability and finding them insufficient for current devices sizes (16-18) ....
-
Fraudulent purchase of designated accessible seating. (Section-by-Section Analysis)
The Department has received numerous comments regarding fraudulent attempts to purchase wheelchair spaces for patrons other than those who use wheelchairs. ...
-
Introduction
Linear distances between pairs of measured points can be computed to provide dimensional estimates of body and mobility device sizes....
-
B. Notice of the ADA’s Provisions
Regardless of Size, the ADA Notice Requirement Applies The ADA notice requirement applies to ALL state and local governments covered by title II, even localities with fewer than 50 employees...
-
608.2.2 Standard Roll-In Type Shower Compartments
Figure 608.2.2 Standard Roll-In Type Shower Compartment Size and Clearance...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Note: inside finished dimensions measured at the center points of opposing sides Figure 608.2.3 Alternate Roll-In Type Shower Compartment Size and Clearance...
-
608.2.2.1 Clearance
Figure 608.2.2 Standard Roll-In Type Shower Compartment Size and Clearance...
-
10.2.1(3)
Signs that are sized to the maximum dimensions permitted under legitimate local, state or federal regulations or ordinances shall be considered in compliance with 4.30.2 and 4.30.3 for purposes...
-
R103 Conventions (Section-by-Section Analysis)
Where the required size or dimension of a facility or element is based on ratios or percentages, rounding down for values less than one half is permitted....
-
4.8.4 LANDINGS
(3) If ramps change direction at landings, the minimum landing size shall be 60 in by 60 in (1525 mm by 1525 mm)....
-
Job Accommodation Network
It soon expands to serve private employers of all sizes, government agencies, employee representatives and service providers, as well as people with disabilities and their families....