resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
Search Results "Lavatory Height"
Filters
Commonly Searched Documents
-
ALTERATION
-
Thresholds [§404.2.5]
Thresholds [§404.2.5] The height of thresholds is limited to 1/2” in new construction. The edge must be beveled 1:2 maximum above a height of 1/4”....
-
Breast Platform [M303.4.1]
The upper height range for the breast platform was not controversial and remained as proposed except for the designation of this as a minimum upper height....
-
11B-306.3.4 Clearance reduction
inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches (152 mm) in height...
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
maximum height above 19 inches, be provided in order to better accommodate users of powered wheelchairs and scooters....
-
M303.4.1 Breast Platform Adjustability
Breast platforms shall be continuously adjustable from a low height of 26 inches (660 mm) to a high height of 42 inches (1065 mm) above the floor....
-
102 Dimensions for Adults and Children
addition, technical requirements are also provided based on children’s dimensions and anthropometrics for drinking fountains, water closets and other elements located in toilet compartments, lavatories...
-
4.23.3 CLEAR FLOOR SPACE
EXCEPTION: In bathrooms with only one water closet, one lavatory, and one bathtub or shower, a clear floor space of 30 in by 60 in (760 mm by 1525 mm) may be used in lieu of the unobstructed...
-
A4.22.3 Clear Floor Space
It is important to keep in mind that the placement of the lavatory to the immediate side of the water closet will preclude the side approach transfer illustrated in Figure A6(b)....
-
4.30.2* Character Proportion
Letters and numbers on signs shall have a width-to-height ratio between 3:5 and 1:1 and a stroke-width to- height ratio between 1:5 and 1:10....
-
4.30.2* CHARACTER PROPORTION
Letters and numbers on signs shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10....
-
11B-502.8.2 Lettering
The additional sign shall clearly state in letters with a minimum height of 1 inch (25 mm) the following: "Unauthorized vehicles parked in designated accessible spaces not displaying...
-
B4. Vertical Clearance
Is the vertical height for the vehicle route to the loading zone, the drop off area, and the exit at least 114 inches (9 feet 6 inches) in height?...
-
Water Closet Clearance
Section 604.3 of the 2010 Standards represents a change in the accessibility requirements where a lavatory is installed adjacent to the water closet....
-
TTYs
Commenters urged that a higher surface height for TTY keypads be specified....
-
6.1 Deliberative Process
6.1 Deliberative Process Box 6.1 shows the transfer surface height recommendation in the February 2012 Notice of Proposed Rulemaking on MDE accessibility standards (Section 1.3)....
-
Addendum A: List of Terms
seat to floor height....
-
Notes
Notes Z Seated height became the de facto height measurement method because this height is most relevant to clinicians as they conduct physical examinations of patients. ...
-
COST OF EQUIPMENT
Range Average Price Price Increase Configuration #1: Accessible equipment as currently available on the market, standard chair arms and stirrups 19 inch max. height...
-
Verify Electrical
Heights of all 30 amp or less outlet boxes. Measure to top or bottom of boxes 11B-308.1.1 Heights of all electrical switch boxes....
-
Verify Electrical
Heights of all 30 amp or less outlet boxes. Measure to top or bottom of boxes 11B-308.1.1 Heights of all electrical switch boxes....
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
11B-809.10.6.4 Reinforcement for grab bars
The grab bar reinforcement shall be 8 inches (203 mm) minimum in height....
-
8.4 Card Catalogs and Magazine Displays
Maximum reach height shall comply with 4.2, with a height of 48 in (1220 mm) preferred irrespective of approach allowed....