(iv) the type of operation or operations of the covered entity, including the composition, structure, and functions of the workforce of such entity; the geographic separateness, administrative...
Search Results "Independent Operation"
-
12111(10)(B)(iv)
-
§1630.2(p)(2)(iv)
(iv) The type of operation or operations of the covered entity, including the composition, structure and functions of the workforce of such entity, and the geographic separateness and administrative...
-
11B-606.4 Faucets
Controls for faucets shall comply with Section 11B-309 _|Operable Parts|_. Hand-operated metering faucets shall remain open for 10 seconds minimum....
-
§ 37.193(a)
(a) Until 100 percent of the fleet of a large or small operator uses to provide fixed-route service is composed of accessible OTRBs, the operator shall meet the following interim service...
-
Height Requirements
This exception’s coverage of various operable parts was considered to be too broad. Response....
-
Paragraph (g) (Advisory Guidance)
Paragraph (g) Operable without Time-Dependent Controls 1. Many persons find it very difficult to operate time-dependent controls. 2....
-
§ 37.189(d)
(d) If the individual with a disability does not provide the advance notice the operator requires under paragraph (a) of this section, the operator shall nevertheless provide the service...
-
Undue Hardship
Undue Hardship An employer is not required to provide an accommodation if it will impose an undue hardship on the operation of its business....
-
407.12.2.2 Obstructed Side Reach
Where the operable part is located more than 10 inches (255 mm), but not more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches...
-
COMMENTS
Department believes that legitimate safety requirements, including crime prevention measures, may be taken into account so long as they are based on actual risks and are necessary for safe operation...
-
CS Pocket Insert Track Demo
This system is ideal for use in applications where longevity of use and smooth operation are required....
-
Section 1630.2(p) Undue Hardship
Section 1630.2(p) Undue Hardship An employer or other covered entity is not required to provide an accommodation that will impose an undue hardship on the operation of the employer's...
-
3. May an employer specifically ask what type of assistance will be needed?
For example, it would be important for an employer to know whether someone who uses a wheelchair because of mobility limitations is able to walk independently, with or without the use of...
-
A4.30.1 General
In building complexes where finding locations independently on a routine basis may be a necessity (for example, college campuses), tactile maps or prerecorded instructions can be very helpful...
-
4.21.2 Size and Clearances
However, because users were not expected to independently maneuver their wheelchairs, the critical issues regarding floor space both outside and inside the shower were the amount of space...
-
Water closet
Alternatively, for individuals capable of independent transfer, grab bars on both sides would enable them to pull up to a standing position and lower down to a sitting position (Sanford...
-
1002.5 Amusement Ride Seats Designed for Transfer
The proximity of the clear floor or ground space next to an element and the height of the element one is transferring to are both critical for a safe and independent transfer....
-
III-4.4100 General
Conventional doorknobs and operating controls may impede access by people who have limited manual dexterity....
-
11B-404.3.6 Break out opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (813 mm) minimum when operated...
-
11B-233.3.2.1 Buyer identified residential dwelling units for sale
The requirements of Section 11B-233.3.2 also apply to housing programs that are operated by public entities where design and construction of particular residential dwelling units take place...
-
11B-239.2 Minimum number
If a course is designed with the minimum 50 percent accessible holes, designers or operators are encouraged to select holes which provide for an equivalent experience to the maximum extent...
-
11B-233.3.2.1 Buyer identified residential dwelling units for sale
The requirements of Section 11B-233.3.2 also apply to housing programs that are operated by public entities where design and construction of particular residential dwelling units take place...
-
11B-404.3.6 Break out opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (813 mm) minimum when operated...
-
11B-239.2 Minimum number
If a course is designed with the minimum 50 percent accessible holes, designers or operators are encouraged to select holes which provide for an equivalent experience to the maximum extent...
