This point applies to all vehicle acquisition provisions of this regulation, whether for rail or non-rail, private or public, fixed route or demand responsive vehicles and systems....
Search Results "Fixed Table"
Commonly Searched Documents
-
Section 37.85 Purchase or Lease of New Intercity and Commuter Rail Cars
-
Transfer Protocols
His data were not included in the result tables. Two participants (P2 and P3) did not attempt to transfer higher or lower than their mobility seat for different reasons. ...
-
Small Businesses
Small Business Administration, Industry and Employment Size of Enterprise for 1994, Table 7, SIC 3561 (U.S....
-
Mobility Use Demographics
Tables D4 and D5 show the breakdown of gender and mobility type by self-reported disability for phase 1 and phase 2. Table D4....
-
3.1.1. Total Number of U.S Auditoriums (2015)
Table 3-1 presents a summary of this information. The data is provided by Deluxe Technicolor Digital Cinema and United Drive-In Theatre Owners Association (UDITOA)....
-
H. Barriers Affecting Accessibility and Usability of Medical Diagnostic Equipment
respondents who had experience with specific medical equipment rated their degree of difficulty when attempting to access or use the equipment as follows: • 75 percent rated examination tables...
-
Transfer Surface Size: Equipment Used by Patients in Supine, Prone, or Side-Lying Position (M301.2.2)
ANSI/AAMI HE75 notes that a standard examination table is 27 inches wide and a bariatric table is approximately 30 to 32 inches wide and recommends wider surfaces to make repositioning easier...
-
A. Executive Order 13563 and 12866—Regulatory Planning and Review
The annual one-time training cost for all postsecondary institutions is presented in Table 1 below....
- Mansfield Cascade Commercial Package Urinal and Flush Valve CP-410
- Guldmann GH1 F Lifting Module
- Kawneer North America 1040 Sliding Mall Front Door
- Whitehall Mfg. Single Temp Piezo Pushbutton Electronic Valve Conical Faucet 4" Centerset
- Cavity Sliders USA Inc. FH Ceiling Mount Track
-
Negotiations Between the Senate and the White House
Kennedy and Harkin wanted disability representatives to be at the table because they had so much technical expertise, but they and all other outside constituencies were not allowed into...
-
11B-212.3 Sinks
A fixed bowl or basin with running water and drainpipe, as in a kitchen or laundry, for washing dishes, clothing, etc. (As differentiated from the definition of "Lavatory".). ...
-
3.3.16 Door Use
Table 3‒5 summarizes the descriptive statistics for the sub-sample. The sub-sample was on average younger than the overall sample (see Table 3‒2)....
-
Base Support [No specific provision—affects M303.2.4]
The anthropomorphic data, as well as the calculated footrest clearances, are below in Tables 4 and 5. Table 4....
-
11B-703.8.4 Character height
The uppercase letter “I” of the font shall have a minimum height complying with Table 11B-703.8.4. ...
-
11B-407.4.1 Car dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Table 11B-407.4.1....
-
Accessible Route Into and Through the Business
blowers, if the maneuvering clearance alongside the entrance door is blocked by a sale book rack, or if a route contains scattered trip hazards from impulse items displayed on cloth-covered tables...
-
Do facilities in remote locations have to be accessible?
Any facility newly constructed or significantly altered by or for the Forest Service (buildings, toilets, picnic tables, fire rings, etc.), must be accessible, with very few exceptions....
-
704.8 Allowable area of openings
The maximum area of unprotected or protected openings permitted in an exterior wall in any story shall not exceed the values set forth in Table 704.8....
-
Slopes and Resting Intervals for Beach Access Routes
access route isn't designed as a series of steep segments, no more than 15 percent of the total length of the beach access route may exceed a slope of 1:12 (8.33 percent), as shown in table...
-
4.3.1 Reference WhMD Users
The Reference Users should include plan and elevation drawings and have key dimensions coded with a corresponding table of values for each code showing the 5th, 25th, 50th, 75th and 95th...