Search Results "Door Surface"
- AD Systems’ Door-Swing - Single
-
Why a smooth surface door or kickplate is important
This video shows what can happen if the push side of a door near the floor isn't smooth. Â ...
- Figure 404.2.4.2(b) Maneuvering Clearances at Doorways without Doors, Sliding Doors, Gates, and Folding Doors – Drawing from the U.S. Access Board
- Figure 404.2.4.2(d) Maneuvering Clearances at Doorways without Doors, Sliding Doors, Gates, and Folding Doors – Drawing from the U.S. Access Board
- Figure 404.2.4.2(c) Maneuvering Clearances at Doorways without Doors, Sliding Doors, Gates, and Folding Doors – Drawing from the U.S. Access Board
- Panda TS.87 Lift & Slide Slim Profile Thermally Broken Corner Sample
- Panda TS.87 Thermally Broken Slim Profile Lift & Slide System
- 1510 Series Electromagnetic Door Lock and installation video
-
§ 38.95(b)(6) Platform surface
(6) Platform surface. The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
-
M7
If the door swings into the room, does the door swing not overlap the required clear floor space for the toilet or lavatory?...
- Landscape Forms GO Outdoor Table
- Mobi-mat® Recpath Demonstration Video
- Mobi-Mat® installation
- Access Board: Accessible Route Openings
- Pilot Rock T-600 Series Caterpillar Picnic Table
- Beneficial Designs
- Pilot Rock AT Series Traditional A-Frame Picnic Table With Steel Braces - Using Lumber
-
3.3 Guidance on the Visual Properties of Detectable Warnings
Two relatively dark surfaces may provide high luminance contrast, but on asphalt or other dark sidewalk surfaces (with reflectance less than 10 percent) high contrast is not always a good...
-
11B-1008.2.6.2 Use zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
-
11B-1008.2.6.2 Use zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
-
11B-1008.2.6.2 Use zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
- S.51 All Aluminum Corner Detail
- Panda S.85/S.90 Sliding Systems Corner Detail
- TS.19 Thermally Broken Lift & Slide System Corner Detail