(b) For purposes of registration, the estimated cost of construction for the project shall be based on the pedestrian elements only....
Search Results "Clearance in Base"
-
68.102(b) Estimated cost of construction
-
Breed limitations. (Section-by-Section Analysis)
The Department does not believe that it is either appropriate or consistent with the ADA to defer to local laws that prohibit certain breeds of dogs based on local concerns that these breeds...
-
Breed limitations. (Section-by-Section Analysis)
The Department does not believe that it is either appropriate or consistent with the ADA to defer to local laws that prohibit certain breeds of dogs based on local concerns that these breeds...
- Hoyer Journey Stand-Up Lift
- Hill-Rom Liko® M220 / M230 Mobile Lift
-
M305.3.2 Height
The height of gripping surfaces for standing supports shall be based on the position of the standing supports in relation to the standing surfaces they serve....
-
§8.4(e)
(e) The obligation to comply with this part is not obviated or alleviated by any State or local law or other requirement that, based on handicap, imposes inconsistent or contradictory prohibitions...
-
2.4.1
2.4.1 Based on the methods for measuring compliance, define what remedial actions are acceptable when construction elements exceed tolerances....
-
§ 38.159(a)(2) Exception
If portable or station-based lifts, ramps or bridge plates meeting the applicable requirements of this section are provided at stations or other stops required to be accessible under regulations...
-
404.3.1 Clear Width
The minimum clear width for automatic door systems in a doorway shall be based on the clear opening provided by all leaves in the open position....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at 2013 CBC 11B-806.2.3.1 is not required by 2010 ADAS....
-
Is there a minimum distance between changes in level?
Ramps and curb ramps, which must be used to span vertical changes greater than ½”, must have level landings and clearances at the tops and bottoms of each run to provide adequate separation...
-
Protrusion Limits [§307.2]
Those with leading edges that are within cane sweep (27” high maximum) or that provide minimum headroom clearance (80” minimum) do not pose hazards and can protrude any amount....
-
§ 38.23(a) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADAS....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADA Standards....
-
Section 1630.10(b)—Qualification Standards and Tests Related to Uncorrected Vision
Section 1630.10(b)—Qualification Standards and Tests Related to Uncorrected Vision This provision allows challenges to qualification standards based on uncorrected vision, even where...
-
Introduction
Communities are best understood by their own residents—a fact that makes community-based emergency planning and response highly effective....
-
Current industry standard practices resulting from this project
The research was conducted by the University of Pittsburgh Human Engineering Research Laboratory and was based on exposure limits of vibration to the human body established in ISO 2631,...
-
The ADA and Its Integration Mandate
The Supreme Court held that public entities are required to provide community-based services to persons with disabilities when (a) such services are appropriate; (b) the affected persons...
- Magnuson Group KOBE Hook
- Mockett CH11 Longhorn Coat Hook
- BEA Inc. LZR-Microscan Swinging Door Sensor
-
3.0 Comparison of Research Methodologies
The BS8300:2001 research covered knee and toe clearances, reaching abilities of wheeled mobility users, clear floor area space requirements and maneuvering clearances....