The 2016 California Plumbing Code (CPC), Table 422.1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
Search Results "Existing Trail"
-
11B-213.3 Plumbing fixtures and accessories
-
Subpart B -- General Requirements (Section-By-Section Analysis and Response to Comments)
These general prohibitions are patterned after the basic, general prohibitions that exist in other civil rights laws that prohibit discrimination on the basis of race, sex, color, religion...
-
68.30(3) Van Accessible Parking at Garages Constructed Prior to April 1994
Parking garages where construction was started before April 1, 1994, and the existing vertical clearance of the garage is less than 98”, are exempted from requirements to have van-accessible...
-
2. Priority Guidelines for Removal of Access Barriers
Priority Guidelines for Removal of Access Barriers In selecting, removing, and remediating existing access barriers, the City will exercise its discretion and give priority to Pedestrian...
-
11B-213.3 Plumbing fixtures and accessories
The 2016 California Plumbing Code (CPC), Table 422.1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
-
11B-407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1372 mm) maximum above the finish floor when a parallel approach is provided...
-
11B-608.7 Thresholds
Exception: A threshold 2 inches (51 mm) high maximum shall be permitted in transfer type shower compartments in existing facilities where provision of a ½ inch (12.7 mm) high threshold would...
-
608.7 Thresholds
EXCEPTION: A threshold 2 inches (51 mm) high maximum shall be permitted in transfer type shower compartments in existing facilities where provision of a ½ inch (13 mm) high threshold would...
-
407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1370 mm) maximum above the finish floor where a parallel approach is provided...
-
Community Resources for Independence (CRI) - Allentown, Indiana, Erie, Altoona, Bradford, Clearfield, Hermitage, Lewisburg, Lewiston, McConnellsburg, Seneca, Warren, Wellsboro, and Somerset, PA
CRI's professionally trained staff, many of whom have disabilities themselves, provide services, peer support, and referrals to existing community resources. ...
-
Number Limits
view of the matter has been strengthened by the fact that, during the 17 years since the original rule was issued, we are not aware of any instances of safety problems resulting from the existing...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
1. Program Access
redesign of equipment, reassignment of services to accessible buildings, assignment of aides to beneficiaries, home visits, delivery of services at alternate accessible sites, alteration of existing...
-
Alterations
“Technically infeasible” is defined as something that has little likelihood of being accomplished because existing structural conditions would require removing or altering a load-bearing...
-
405.1 General (Section-by-Section Analysis)
This proposed section closely corresponds to existing 508 Standards §§ 1194.21(k), 1194.22(j), and 1194.25(i), and is similar to § 1193.43(f) of the existing 255 Guidelines....
-
Evaluating the Physical Accessibility of Polling Places
Planning for an upcoming election also gives elections officials the opportunity to improve existing polling places that are not accessible by using temporary elements, such as portable...
-
4.34.4 CONSUMER INFORMATION
To ensure that the existence of adaptable features will be known to the owner or occupant of a dwelling, the following consumer information shall be provided in each adaptable dwelling unit...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
206.2.5 Restaurants and Cafeterias
In alterations, an accessible route shall not be required to existing raised or sunken dining areas, or to all parts of existing outdoor dining areas where the same services and decor are...
-
404.2.10 Door and Gate Surfaces
ETA Editor’s Note: An existing door with a noncompliant kick plate is a safe harbored element for path of travel and barrier removal purposes but will have to comply when the door is...
-
1133B.2.3.2
The provisions of Section 1133B.2.3 shall not apply to existing buildings, except when otherwise required under conditions applicable to access for persons with disabilities....
-
Costs to Provide Accessible Pedestrian Signals and Pedestrian Pushbuttons (Section-by-Section Analysis)
estimated that pedestrian signals are newly installed or replaced at 13,095 signalized intersections on an annual basis based on the following assumptions: There are over 300,000 existing...
