ILLUSTRATION 4: A municipal performing arts center provides seating at two prices -- inexpensive balcony seats and more expensive orchestra seats....
Search Results "L-Shaped Seat"
-
II-5.2000 Methods for providing program accessibility.
-
11B-206.2.5 Restaurants, cafeterias, banquet facilities and bars
accessible route between stories, an accessible route shall not be required to a mezzanine dining area where the mezzanine contains less than 25 percent of the total combined area for seating...
-
11B-206.2.5 Restaurants, cafeterias, banquet facilities and bars
accessible route between stories, an accessible route shall not be required to a mezzanine dining area where the mezzanine contains less than 25 percent of the total combined area for seating...
-
d. ii.
Provide handles, locks and other operating devices that have a shape that is easy to grasp with one hand and does not require tight grasping and twisting actions of the wrist to operate...
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
The diameter or width of the gripping surfaces of a handrail or grab bar shall be 1-1/4 in to 1-1/2 in (32 mm to 38 mm), or the shape shall provide an equivalent gripping surface....
-
304 Turning Space
304 Turning Space Section 4.2.3 of the 1991 Standards and Section 304.3 of the 2010 Standards allow turning space to be either a circular space or a T-shaped space....
-
Re: American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
If seated in a wheelchair, the angle to graps the handl hold would not be possible. The strap was left dangling to use as an opener....
-
11B-703.3.1 Dimensions and capitalization
Braille dots shall have a domed or rounded shape and shall comply with Table 11B-703.3.1....
-
11B-703.3.1 Dimensions and capitalization
Braille dots shall have a domed or rounded shape and shall comply with Table 11B-703.3.1....
-
General: ADA Standard Section 405.1
Section 405.1 of the ADA Standards covers information in the current ADA Standards for ramps.
-
Size: ADA Standard Section 903.3
Benches shall have seats that are 42 inches (1065 mm) long minimum and 20 inches (510 mm) deep minimum and 24 inches (610 mm) deep maximum....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests. ...
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
Structural Strength: ADA Standard Section 903.6
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Ticketing (Assembly areas, not parking.)
People purchasing a ticket for an accessible seat may purchase up to three additional seats for their companions in the same row and these seats must be contiguous with the accessible seat...
-
Authorization by the Attorney General
L. 101-336, 42 U.S.C. 12186, and for the reasons set forth in the preamble, Chapter I of title 28 of the Code of Federal Regulations is proposed to be amended as follows: PART 36-NONDISCRIMINATION...
-
502.3.4 Label Relationships (Section-by-Section Analysis)
This provision corresponds to §§ 1194.21(l) and 1194.22(n) in the existing 508 Standards, though it is broader in scope since, unlike these current requirements, its coverage extends beyond...
-
10) Assembly areas
10) Assembly areas ADAAG: * Wheelchair seating: Requirements triggered in any assembly area with fixed seating that seats four or more people....
-
A4.33.3 Placement of Wheelchair Locations
Building/life safety codes set minimum distances between rows of fixed seats with consideration of the number of seats in a row, the exit aisle width and arrangement, and the location of...
-
University of Michigan Transportation Research Institute
UMTRI’s Biosciences Group conducts sled-impact tests of wheelchairs, wheelchair seating systems, and wheelchair tiedowns and occupant-restraint systems (WTORS) to evaluate their frontal-...
-
221 Assembly Areas
seating (221.5)....
-
Door Hardware [4.13.9]
Door Hardware [4.13.9] Hardware used to operate doors, including handles, pulls, latches and locks, must have a shape that is "easy to grasp with one hand" and does not require tight...
