4.3.5.1 90-Degree Turn This turning clearance is applicable for exterior and interior circulation, aisles in seating areas, ramps and other locations....
Search Results "Knee Clearance"
-
4.3.5.1 90-Degree Turn
-
Introduction
Objects that project into circulation spaces from the side or that do not provide at least 80 inches of head clearance can be extremely hazardous to people who are blind or who have low...
-
Water Closet Location.
However, without research data upon which to determine how much space was adequate, side clearance varied, usually dependent on the amount of space available within the overall design of...
- Kohler Sensate Touchless Kitchen Faucet
- citEcar ADA Electric Shuttle 11P 1WC
- citEcar ADA Enclosed Shuttle 11P 1WC
-
ASME: ADA Standard Section 105.2.2
Section 105.2.2 of the ADA Standards cover references to the American Society of Mechanical Engineers (ASME) standards.
-
4. Breast Platform Adjustability
Because this recommendation evolved from technologist experience on equipment with less knee space, disability advocates supported the rationale for 26 inches as the minimum....
-
1133B.2.3.2
The newer regulations are clearly more stringent regarding electrical power and substitution of powered doors for required maneuvering clearances....
-
Accessible Routes Throughout the Museum
Care must be taken either to keep protruding objects or those with low head clearance out of the path of travel or to install cane-detectable barriers below them....
-
Standing Supports (M304.3 and M305.3)
The Access Board is also considering whether a 1½ inches minimum clearance around the gripping surface of standing supports would be appropriate to ensure that the surface can be grasped...
- Pilot Rock UT and UTH Series End Accessible Picnic Table Using Recycled Plastic
- Halsey Taylor Bi-Level Barrier-Free Cooler
-
III-4.1100 General
ILLUSTRATION 2: A parking garage refuses to allow vans to park inside even though the garage has adequate roof clearance and space for vans....
-
ASME
The standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access...
- Pilot Rock XT and XTH Series End Accessible Picnic Table Using Aluminum
- Pilot Rock UT and UTH Series End Accessible Picnic Table Using Steel Tops Seats
- Pilot Rock XT and XTH Series End Accessible Picnic Table - Using Steel Tops and Seats
- Pilot Rock UT and UTH Series End Accessible Aluminum Picnic Table
- Pilot Rock UT and UTH Series End Accessible Picnic Table Using Lumber
-
Feature 2 - Routes to the Building Entrance
Therefore, objects that do not provide sufficient head clearance or that are mounted too high and protrude into a route can become hazards because they cannot be detected by people who are...
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
In the 2010 Standards an exception allows the entry door to swing over the clear floor spaces and clearances required at the fixtures if a clear floor space complying with section 305.3...