Durable, 22-gauge, zinc-plated steel with white epoxy cover with black plastic trim, automatic sensor, dual air outlets, 208-240V AC, 6.8-7.8 Amp, 1400-1900 Watts, 50/60 Hz, Single Phase...
Search Results "Phase Timing"
Filters
Commonly Searched Documents
-
Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.230V
-
Issue 12: Audible beaconing
beaconing -- providing a louder audible WALK signal in order to provide directional guidance to pedestrians who are blind -- is not needed at all intersections or during every pedestrian phase...
-
Ampetronic MLD7 MultiLoop Driver Hearing System
The MLD7 is capable of driving a wide variety of multiple loop configurations from multiple simple loops to phase shifted array systems for the most challenging requirements....
-
Ampetronic MLD5 MultiLoop Driver Hearing System
The MLD5 is capable of driving a wide variety of multiple loop configurations from multiple simple loops to phase shifted array systems for the most challenging requirements....
-
Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.115V
304 satin-finish stainless steel cover having #4 satin-finish vertical grain with black plastic trim, automatic sensor, dual air outlets, 115V AC, 15 Amp, 1725 Watts, 50/60 Hz, Single Phase...
-
Section 37.139 Plan Contents
This section and §37.139 provide for a maximum phase-in period of five years, with an assumed one-year phase-in for all paratransit programs....
-
Conclusions
The stabilizers that have met the requirements for this next phase include the polyurethanes and latex systems....
-
Ampetronic MLD9 MultiLoop Driver Hearing System
The MLD9 provides the highest output available in any dual channel loop driver and is capable of driving a wide variety of multiple loop configurations from multiple simple loops to phase...
-
Looking at Cal Green 5.106.5.3, we must provide the conduits and panel capacity for future installation for the required number of spaces (2 in this case). However, it is only when the equipment is to be installed that we need to refer to CBC and CEC. Section 11B-228.3.1 also reiterates this. Therefore, we would show the location of the conduit stub outs adjacent to 2 current parking spaces and would show space on the electric panel for the future equipment – and that is all. At this time, we do not need to show the requirements for EV accessibility when equipment is installed per Chapter 11B. Is my interpretation correct?
The owner can use this information to determine the sequence and extent of work to be included in each phase of the project....
-
Scoping for timeshare or condominium hotels. (Section-by-Section Analysis)
In some developments, units that may serve as residential units some of the time and rental units some of the time will have to meet both the FHAct and the ADA requirements....
-
Future Work
The next phase of study will research alternative hand placement options for both initial hand placement and repositioning upon landing on the target surface. ...
-
SIGNALIZATION OF ROUNDABOUTS
Pedestrians press a button to request a walk phase. Sensors in the roadway hold the walk phase request until a gap in traffic is detected, or until the signal times out....
-
Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.230V
satin-finish stainless steel cover having #4 satin-finish vertical grain with black plastic trim, automatic sensor, dual air outlets, 208-240 AC, 6.8-7.8 Amp, 11400-1900 Watts, 50/60 Hz, Single Phase...
-
§ 37.139(j)(2)
(2) If the paratransit service is being phased in over more than one year, the entity must demonstrate that the milestones identified in the current paratransit plans have been achieved....
-
§ 37.139(d)(5)
The plan shall include milestones for implementing phases of the plan, with progress that can be objectively measured yearly;...
-
Who Must Comply with Title I of the ADA?
To give smaller employers more time to prepare for compliance, coverage is phased in two steps as follows: Number of employees: 25 or more Coverage begins: July 26, 1992...
-
Designing Sidewalks and Trails for Access, Part II of II: Best Practices Design Guide
This guidebook is the second part of a two-phase project focused on designing sidewalks and trails for access....
-
14.1 Q. How many resident parking spaces must be made accessible at the time of construction?
A. The Guidelines provide that a minimum of two percent of the parking spaces serving covered dwelling units be made accessible and located on an accessible route to wheelchair...
-
R104.2 MUTCD
through 4E.13 of the MUTCD for accessible pedestrian signals and pedestrian pushbuttons; and • R306.2 references standard statements in section 4E.06 of the MUTCD for pedestrian signal phase...
-
Bobrick TrimLineSeries Recessed Paper Towel Dispenser/Automatic Hand Dryer/Waste Bin (3-in-1 Unit) B-38030 230V
., 1500-1700 Watts, 50/60 Hz, Single Phase. 15-1/8” (384mm) x 55-3/4” (1416mm) x 5-5/8” (143mm) recess....
-
Section 36.303(g)(7) Compliance Date for Providing Captioning and Audio Description
The vast majority of commenters, however, asserted that 6 months was not enough time for the remaining movie theaters to comply with the requirements of this rule....
-
Executive Summary
In this phase of the study, an international workgroup of experts came together to exchange ideas and information related to independent transfers and generate a future research agenda....
-
§ 37.137(b)(2) Consultation with individuals with disabilities
Consultation shall begin at an early stage in the plan development and should involve persons with disabilities in all phases of plan development....
-
19. Are new play components added to an existing play area required to comply with the Standards even if there is not an accessible route from parking or the street to the play area?
It is anticipated that many play areas will be updated and altered in phases....
