Section 1008.2.6 of the 2010 Standards provides technical requirements for accessible ground surfaces for play areas on accessible routes, clear floor or ground spaces, and turning spaces...
Search Results "Technical Requirement"
Filters
Commonly Searched Documents
-
Ground Surfaces
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
INTRODUCTION:
Questions, Accessible Route & Path of Travel Questions, Scoping Questions, Technical Questions, and Miscellaneous Questions The questions are...
-
Passing Spaces on Trails
clear tread width of a trail is less than 60 inches (1,525 millimeters), provide passing spaces at least every 1,000 feet (300 meters) and at the end of any segment of trail that meets the technical...
-
Overview of FSTAG Implementation Process:
**Refer to FSTAG for detailed instructions, definitions, and technical provisions 7.0 through 7.3....
-
Q13: Are the provision and implementation of a health plan developed prior to the Amendments Act sufficient to comply with the FAPE requirements as described in the Section 504 regulation?
The critical question is whether the school district's actions meet the evaluation, placement, and procedural safeguard requirements of the FAPE provisions described in the Section 504 regulation...
-
ADA Guide for Small Towns
Disclaimer The ADA authorizes the Department of Justice to provide technical assistance to individuals and entities that have rights or responsibilities under the Act....
-
Overhead Lifts
The technical criteria do not address overhead lifts that are usually mounted on the ceiling and operate on tracks suspended over the diagnostic equipment because the configuration of the...
-
Completing the Checklist
The checklist is based on requirements from the ADA Standards for Accessible Design (Standards)....
-
Background
When the 2010 ADA Standards for Accessible Design (2010 ADAS) were adopted by DOJ on September 15, 2010, these became the initial basis for the accessibility requirements of CBC Chapter...
-
305.3, 902.1 and 902.2 Baby Changing Table Clear Floor Space
This video shows how to measure the required clear floor space at a baby changing table....
-
6. Modifications to the Functional Performance Criterion for Limited Vision
Industry groups suggested that the proposed visual acuity criterion contradicted several technical requirements....
-
11B-403.3 Slope
When the running slope of a walking surface exceeds 5%, it must comply with the accessibility requirements for ramps....
-
24 CFR Part 100—Fair Housing Accessibility Guidelines, Preamble
SUMMARY: This document presents guidelines adopted by the Department of Housing and Urban Development to provide builders and developers with technical guidance on how to comply with the...
-
708 Two-Way Communication Systems
As part of the integration of requirements for residential dwelling units from a separate chapter, provisions specific to communication systems in such facilities have been relocated to...
-
If the lift manufacturer specifies that wheelchairs must face away from the vehicle when using the lift, are transportation operators required to permit passengers to board facing the vehicle?
If the lift manufacturer specifies that wheelchairs must face away from the vehicle when using the lift, are transportation operators required to permit passengers to board facing the vehicle...
-
F233 Residential Facilities
The scoping and technical requirements in this Standard were developed by the U.S. Access Board for all Federal facilities....
-
106 Definitions
The following definitions have been removed as unnecessary, in most cases due to changes in certain scoping or technical requirements: "accessible route," "area of refuge," "automatic door...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
In this case, existing ground level play components are not required to meet the technical provisions of Section 1008.4....
-
Application to specific scenarios raised in comments. (Section-by-Section Analysis)
that in some cases replacement of a broken fixture might necessitate moving a number of other accessible fixtures (such as in a bathroom) in order to comply with the fixture and space requirements...
-
3. Does the ADA require an applicant to disclose that she has or had a hearing impairment or some other disability before accepting a job offer?
Does the ADA require an applicant to disclose that she has or had a hearing impairment or some other disability before accepting a job offer? No. ...
-
Section 36.406 Standards for New Construction and Alterations (Section-By-Section Analysis and Response to Comments)
Section 4 contains scoping provisions and technical specifications applicable to all covered buildings and facilities....
-
B. The ADA Standards for Accessible Design
They establish the minimum scoping and technical requirements for a facility or part thereof to be “readily accessible to and usable by individuals with disabilities.” 2010 Standards, Overview...
-
C.2. - If EIT is acquired through another agency’s contract, which agency is responsible for Section 508 compliance?
This responsibility remains with the requiring agency irrespective of the vehicle used to complete the transaction -- e.g., the requiring activity has this responsibility when its agency...
