Features Constant Pressure Paddle Switch with Emergency Stop 4 Removable Caster Wheels Automatic Folding Ramp Platform Gate on Exit Side 36" x 54...
Search Results "Ramp Landing"
Commonly Searched Documents
- Harmar CPL400P Portable Vertical Platform Lift
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level ...
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
Blind was a member of the advisory committee that recommended the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps...
-
R302.6 Cross Slope
Cross slope requirements are contained in R304.5.3 for curb ramps and blended transitions, and in R407.3 for ramps....
-
Slope [4.3.7]
Where the running slope of an accessible route exceeds 5% it must be treated as a ramp or curb ramp. A maximum cross slope of 2% is recognized for drainage....
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....
-
907.5.2.3 Visible alarms
Visible alarm notification appliances shall not be required in enclosed exit stairways, enclosed exit ramps, exterior exit stairs and exterior exit ramps. 3....
-
[F] 907.5.2.3 Visible alarms
Visible alarm notification appliances shall not be required in enclosed exit stairways, enclosed exit ramps, exterior exit stairs and exterior exit ramps....
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....
-
B8. Accessible Route
Does an accessible route connect the curb ramp to the accessible entrance? [ADA Stds 4.1.2(1)]...
-
Suggestion by Eldon Tipping
Eldon Tipping As published in Concrete Construction magazine, September 1998, Eldon Tipping made suggestions for a specification for sloped random - traffic floors such as parking decks, ramps...
-
4. Grievance Procedure
Curb ramp requests submitted through the City's grievance procedure trigger an investigation by DPW....
-
11B-303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). FIGURE 11B-303.3 BEVELED CHANGE IN LEVEL...
-
T503.5 Exterior Illumination for Boarding and Alighting Areas
Where doorways have ramps, bridgeplates or lifts, the illumination shall be 1 foot-candle (11 lux) minimum for a distance of 3 feet (915 mm) measured beyond the edge of the ramp, bridgeplate...
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level...
-
Handrails
Handrail extensions are required at the top landing but not at the bottom. The clear width between handrails must be between 33 and 38 inches....
-
1003.2.13.2 Enclosed stairways
of an accessible means of egress, shall have a clear width of 48 inches (1219 mm) minimum between handrails and shall either incorporate an area of refuge within an enlarged floor-level landing...
-
Selection of Participants
Forest Service, and Bureau of Land Management....
-
Areas of Rescue Assistance [4.1.3(9), 4.3.11]
Section 4.3.11 outlines specific areas that may be designed as an area of rescue assistance, including stairway landings, exit balconies, and corridors....
-
Background
These are just a few of the problems faced by Land Managers who are trying to make decisions on natural surfacing materials that create a firm and stable trail....
-
f-ii
Is the change in level from the floor to the lift surface ramped or beveled? [ADA Standards §§ 4.11.2, 4.5.2] Yes No...