6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
Search Results "Hand-Held Shower Unit"
Commonly Searched Documents
-
1132A.3, Item 6
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
§100.5(c)
(c) Nothing in this part relieves persons participating in a Federal or Federally-assisted program or activity from other requirements applicable to buildings and dwellings.
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following:
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
1133A.2.1, Item 2
2. U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward...
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following: The knee and toe space shall be clear and unobstructed, or removable...
-
11B-809.10.8.6 Controls
Faucet controls and operating mechanisms shall comply with Section 11B-309.4.
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor. Where towel bars are provided they shall be...
- Mega Jailhouse Anti-Suicide Grab Bar with Closure Plate 48 inches - Concealed Mounting
-
Step 2: Identify the Presence of Limiting Factors
You can perform an informal survey between obvious trail slope breaks with a hand level, survey rod, and measuring chain (figure 141). You can use a digital level (figure 142)....
-
11B-233.3.1.2.6.5 Additional requirements.
1. Grab bar reinforcement complying with Sections 11B-809.10.5.2, 11B-809.10.6.4, or 11B-809.10.7.3. 2. Interior door opening width complying with Section 11B-404.3.1. 3....
- Murdock Manufacturing Grab Bars
- Bradley Grab Bars 1 1/2" with Concealed Mounting 812
- Comfort Designs Comfort Care™ Grab Bars
-
11B-809.8 Doors
Primary entry doors, required exit doors, secondary exterior doors and interior doors intended for user passage shall comply with this section and Section 11B-404.2. Doors to small...
-
11B-606.2 Clear floor space
In residential dwelling units, cabinetry shall be permitted under lavatories and kitchen sinks provided that all of the following conditions are met: (a) the cabinetry can be removed...
-
Compliance Determinations by State and Local Jurisdictions
A few commenters questioned the role of States and units of local government in determining compliance with the Act's accessibility requirements....
-
7(2)(a)
(a) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Cabinets under lavatories are acceptable provided the...
-
1011.2.1 Size and Location
hook-ups are at the rear center of the space Bollards or other barriers shall not obstruct the clear ground space in front of the hook-ups Outdoor rinsing showers...
- Access Board: Unobstructed Side Reach
- Access Board: Circular Space
- Access Board: Accessible Route Openings