Elevators or other accessible means of vertical movement are not required in residential facilities when: (a) No accessible dwelling units are located above or below the accessible grade...
Search Results "Accessible Unit"
-
4.1.3(1) ELEVATORS
- World Wide Web Consortium (W3C) Web Accessibility Initiative
-
11B-809.8.3 Door maneuvering clearance.
At the dwelling unit side of the primary entry doors, secondary exterior doors, and required exit doors maneuvering clearances shall be 44 inches (1118 mm) minimum in length measured...
-
22.1 Q. Must the switches on range hood kitchen ventilation fans be in accessible locations?
The Fair Housing Act has no requirements for appliances in the interiors of dwelling units, or the switches that operate them....
-
Using the Beach Access Route Exceptions [1018.1, Exceptions 1 and 2]
After applying all the applicable conditions for exceptions to a beach access route, if an entity determines that it is impracticable to provide a beach access route that meets the technical...
-
C) Accessible Entrance
be on an accessible route....
-
11B-809.10.8.3 Cabinets
Cabinets shall be removable without the use of specialized knowledge and/or tools. The finished floor shall extend to the wall under the lavatory.
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work...
-
11B-809.9.7 Exposed pipes and surfaces
Exposed water supply and drain pipes under sinks and lavatories shall comply with Section 11B-606.5.
-
11B-809.9.7 Exposed pipes and surfaces
Exposed water supply and drain pipes under sinks and lavatories shall comply with Section 11B-606.5.
-
11B-809.10.8.3 Cabinets
Cabinets shall be removable without the use of specialized knowledge and/or tools. The finished floor shall extend to the wall under the lavatory.
-
11B-809.10.7.5 Controls
Controls shall be mounted 44 inches (1118 mm) maximum above the finish floor. The force required to activate controls shall be 5 pounds (22.2 mm) maximum.
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work...
-
11B-809.8.3.1 Floor or ground surface
Floor or ground surface within required maneuvering clearances shall not have slopes exceeding 1:48. Exceptions: The floor or landing at primary entry doors, required exit doors...
-
11B-809.10.7.5 Controls
Controls shall be mounted 44 inches (1118 mm) maximum above the finish floor. The force required to activate controls shall be 5 pounds (22.2 mm) maximum.
-
Accessible Route
Accessible Route. Sections 206.2.14 and 1005.1 of the 2010 Standards require an accessible route to each accessible fishing pier and platform....
-
§100.205(c)(3)
(3) All premises within covered multifamily dwelling units contain the following features of adaptable design:...
-
Example: Town Meeting
The town council considers installing an elevator in the building as well as replacing the existing town hall with a new, fully accessible building, but determines that the town’s limited...
-
Architectural Barriers Act (ABA) and the Americans with Disabilities Act (ADA)
The Architectural Barriers Act requires federal buildings to comply with accessibility standards. The U.S. Access Board, my agency and their Office of Gen....
-
F245.4.3 Routes to Adjacent Recreation Facilities
Where a circulation path connects picnic facilities and adjacent recreation facilities, at least one outdoor recreation access route shall connect picnic units with mobility features to...
- ElectionSource Voter Accessibility "Park Here For Assistance" Sign
-
Outdoor Recreation Access Routes at Trailheads [F247.3.2]
Trailheads are usually accessed by vehicle rather than by hiking....
-
Technical Memorandum TM 2013-12 Number of Accessible Elements and Spaces
TM 2013-12 Number of Accessible Elements and Spaces Effective Date: June 1, 2013 2012 TAS Reference: 201.1 In accordance with TAS 201.1, the standards must be applied to...