ADAAG contains requirements for counters and bars, access aisles, food service lines, tableware and condiment areas, raised speaker's platforms, and vending machine areas (but not controls...
Search Results "Vertical Grab Bar"
Filters
Commonly Searched Documents
-
III-7.8200 Restaurants and cafeterias
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”. ...
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
A7. Curb Ramps
[ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for each 12 inches in length. Yes _____ No _____...
-
4.5.2 Changes in Level
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
4.5.2 CHANGES IN LEVEL
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
Handrails [§504.6, §505]
A vertical clearance 9” minimum between upper and lower handrails will help prevent entrapment....
-
Where Required: Multi-Story Buildings and Facilities [§206.2.3]
provisions in the Standards still apply to stories and mezzanines not served by an accessible route elevators provided anyway must fully comply (as standard or LULA elevators) vertical...
-
§ 38.23(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches, and the transition from roadway or sidewalk to ramp may be vertical...
-
Location: ADA Standard Section 206.3
Section 206.3 covers scoping requirements in the most current ADA Standards for the required locations of accessible routes.
-
Guardian Recessed Safety Station with Drain Pan GBF2173
Shower valve: 1" IPS brass stay-open ball valve with stainless steel “panic bar” actuator. Cover/drain pan: 16 gauge stainless steel combination cover and drain pan....
-
Measuring Door Openings
Door handles and push bars should not be included in the measurements of door opening widths....
-
Corbin Russwin Inc. ED7000 Series Narrow Stile Crossbar Exit Device
The ED7000 Series are available as Rim, Surface Vertical Rod, Mortise and Concealed Vertical Rod devices. ...
-
Husky 24" Line Generator Digital Laser Level
This level may use indoors or out for horizontal (level), vertical (plumb) and square alignment projects....
-
Clearances
The 80-inch minimum vertical clearance requirement remains for circulation areas and accessible routes in the queue line and load and unload areas....
-
§ 38.113(d)(1) Requirements
Vertical alignment may be accomplished by car air suspension, platform lifts or other devices, or any combination....
-
§ 38.83(b)(8) Platform entrance ramp
barrier used as a ramp, shall not exceed a slope of 1:8 measured on level ground, for a maximum rise of 3 inches, and the transition from the station platform or roadway to ramp may be vertical...
-
§ 38.95(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station platform to ramp may be vertical...
-
11B-703.6.1 Pictogram field
The 6-inch vertical dimension applies to the field, not the symbol. The symbol may be smaller than the field....
-
1133B.2.5.2
Latching and locking doors that are hand-activated and which are in a path of travel shall be operable by lever-type hardware, panic bars, push-pull activating bars, U-shaped handles or...
-
902.1 General
Dining surfaces include, but are not limited to, bars, tables, lunch counters, and booths....
-
902.1 General
Dining surfaces include, but are not limited to, bars, tables, lunch counters, and booths....
-
(C) NYCT’s interpretation of the ADA and DOT’s implementing regulations is too narrow.
To address another argument presented by NYCT,1 the ADA Accessibility Guidelines (ADAAG) do not, as NYCT contends, limit the requirement that “a means of accessible vertical access” be provided...
