Search Results "Reflecting Surface"

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4 Transfer Supports Recommendations

  5.4 Transfer Supports Recommendations

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M305.2 Transfer Supports

  Transfer supports shall comply with M305.2.

• Legal Documents > SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICAN AND THE CITY OF WAUKEGAN, ILLINOIS UNDER THE AMERICANS WITH DISABILITIES ACT
  Attachment J

  The bottom edge of the mirror’s reflecting surface is 46 inches above the finished floor. ...

• Webinars, Videos, and Training > Spirit of the ADA
  Boost Your Business - Chapter 4 - Ramps
  

  Boost Your Business - Chapter 4 - Ramps

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1190, Proposed Accessibility Guidelines for Pedestrian Facilities in the Public Right-of-Way: Notice of Proposed Rulemaking (NPRM)
  Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis)

  Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis) When the Access Board issued the 1991 ADAAG, the guidelines contained a requirement for detectable warning surfaces...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.3.1 Permitted Obstructions to Transfer Sides for Equipment Used by Patients in a Supine, Prone, Side-Lying or Seated Position

  5.3.1 Permitted Obstructions to Transfer Sides for Equipment Used by Patients in a Supine, Prone, Side-Lying or Seated Position. A 3-inch maximum obstruction is permitted at transfer...

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-809.9.7 Exposed pipes and surfaces

  Exposed water supply and drain pipes under sinks and lavatories shall comply with Section 11B-606.5.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.3.1 Positioning Support Height Recommendation for Imaging Equipment with Transfer Surfaces

  5.4.3.1 Positioning Support Height Recommendation for Imaging Equipment with Transfer Surfaces For imaging equipment with transfer surfaces, the Committee recommends a positioning support...

• Research and History > Research Documents > National Trail Surfaces Study
  26. Please indicate who installed the trail surface

  Please indicate who installed the trail surface (choose all that apply): Manufacturer Contractor Agency/Organization/Park staff Volunteer Unknown...

• Products and Additional Resources > Products
  AJW Architectural Products U703 Series 16"W x 24"H Adjustable Tilt Channel Frame Mirror - Plate Glass Surface
  

  Product Features Fabricated of #18 gauge stainless steel with #4 satin finish Frame miters are not ground smooth and polished Multiple reflective surfaces available Mirror comes...

• Products and Additional Resources > Products
  AJW Architectural Products U702 Series 16"W x 24"H Adjustable Tilt Angle Frame Mirror - Plate Glass Surface
  

  Product Features Fabricated of #18 gauge stainless steel with #4 satin finish Mitered corners are ground and polished smooth Multiple reflective surfaces available Mirror comes...

• Research and History > Research Documents > Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
  Methodology

  This study was approved by the University of Pittsburgh's Institutional Review Board and all participants provided informed consent before participating in any test procedures.

• State and Local Documents > Guidelines > Accessibility Guidebook for Outdoor Recreation and Trails
  Openings in Outdoor Recreation Access Route Surfaces

  Openings are gaps in the surface of an outdoor recreation access route. Gaps include spaces between the planks on a boardwalk or in a drainage grate....

• Webinars, Videos, and Training > Spirit of the ADA
  Boost Your Business - Chapter 6 - Doors
  

  Boost Your Business - Chapter 6 - Doors

• Federal Documents > Technical Assistance > ADA/Section 504 Design Guide - Accessible Cells in Correction Facilities
  2. Mirrors

  Mirrors: If provided, mirrors need to be mounted with the bottom edge of the reflecting surface no higher than 40 inches above the floor....

• Additional Access Publications > ADA Checklist for Existing Facilities
  Play Areas

    Word Fillable Form (0.4MB) Word Non-Fillable Form (0.3MB) PDF Non-Fillable Form (0.3MB)

• Federal Documents > Standards > Uniform Federal Accessibility Standards (UFAS)
  4.19.6* MIRRORS

  Mirrors shall be mounted with the bottom edge of the reflecting surface no higher than 40 in (1015 mm) from the floor (see Fig. 31)....

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  603.3 Mirrors

  Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  603.3 Mirrors

  Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  11B-603.3 Mirrors

  Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1016 mm) maximum above the finish floor or ground....

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  603.3 Mirrors

  Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....

• Federal Documents > Technical Assistance > 2013 Forest Service Outdoor Recreation Accessibility Guidelines (FSORAG)
  603.3 Mirrors

  Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....

• State and Local Documents > Codes and Standards > 2019 California Standards
  11B-603.3 Mirrors

  Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1016 mm) maximum above the finish floor or ground....