The City's Paving Guidelines permit the City to defer curb ramp installation for a period of up to twenty-four months in cases where there is a pre-planned project that would require demolition...
Search Results "Ramp Landing"
Commonly Searched Documents
- 
    
  
  d) Paving Guidelines
  
 - 
    
  
  OTHER SPECIFIC BARRIERS
  
Exhibit A to this Complaint identifies missing and Inaccessible curb ramps at various locations within the City's pedestrian right of way....
 - 
    
  
  Detectable Warnings [§406.8 (DOT’s Standards), §705]
  
Detectable Warnings [§406.8 (DOT’s Standards), §705] Detectable warnings are required on curb ramps at transit facilities covered by DOT’s Standards (facilities used by state and...
 - 
    
  
  Suggestions by Jean Tessmer
  
Suggestions by Jean Tessmer As published in Concrete Technology Today, April 2001, Jean Tessmer, accessibility consultant for Space Options, suggested that ramp slopes be measured with...
 - National AgrAbility Project
 - 
    
  
  Acknowledgments
  
available on the Internet at: http://www.fs.fed.us/t-d/pubs/htmlpubs/htm06232340/drawings/ (Username: t-d, Password: t-d) These drawings can be viewed by Forest Service and Bureau of Land...
 - 
    
  
  Appalachian Trail Conservancy's "Backcountry Sanitation Manual"
  
Resolving problems of backcountry sanitation is a continuous challenge for trail clubs and land managers....
 - 
    
  
  1132A.5.1 General
  
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
 - 
    
  
  1132A.5.1 General
  
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
 - Kompan, Inc. Miram GXY926
 - Freedom Resource Center for Independent Living, Inc. - Fargo, Jamestown, Wahpeton, ND. and Fergus Falls, MN
 - 
    
  
  1.2.2
  
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
 - 
    
  
  11B-303.3 Beveled
  
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). ...
 - Otis Gen2 Elevator
 - 
    
  
  6b.
  
Is the change in level from the floor to the lift surface ramped or beveled? Yes _____ No _____...
 - 
    
  
  ACTIONS TAKEN BY CITY OF WAUKEGAN
  
The City installed an interior ramp that was meant to provide access from the old city hall to the new city hall addition. ...
 - 
    
  
  Construction Specification Institute
  
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...
 - 
    
  
  11B-108 Maintenance of accessible features
  
It is not sufficient to provide features such as accessible routes, parking, elevators, ramps or signage if those features are not maintained in a manner that enables individuals with disabilities...
 - 
    
  
  Areas of Rescue Assistance [4.1.3(9), 4.3.11]
  
Section 4.3.11 outlines specific areas that may be designed as an area of rescue assistance, including stairway landings, exit balconies, and corridors....
 - 
    
  
  Background
  
These are just a few of the problems faced by Land Managers who are trying to make decisions on natural surfacing materials that create a firm and stable trail....
 - 
    
  
  i.
  
"Suspicious Minds" Exhibit ramp leading to the exhibits; and See Standards § 4.8.5(3)....
 - 
    
  
  T402.4 Emergency Operation
  
Power-operated ramps and bridgeplates shall be capable of manual operation in the event of a power failure....
 - 
    
  
  Homemods.org
  
., grab bars, ramps), moving furnishings, changing where activities occur (e.g., sleeping on the first instead of second floor) and renovations (e.g., installing a roll-in shower)....
 - 
    
  
  R305 Detectable Warning Surfaces (Section-by-Section Analysis)
  
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....