equipment will be required to comply with the Standards’ technical requirements....
Search Results "Referenced Standard"
-
A. Final Regulatory Assessment (EO 13563 and EO 12866)
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
An analysis under the 2010 Standards starts with the requirement that all spaces must be accessible unless specifically exempted. 2010 Standards, § 201.1. ...
-
11B-233.3.2 Residential dwelling units for sale
[2010 ADA Standards] 233.3.2 Residential Dwelling Units for Sale....
-
11B-206.2.4 Spaces and elements
[2010 ADA Standards] 1....
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
-
11B-403.3 Slope
. ◼ ETA Editor's Note The 2022 CBC Exception at 11B-403.3 is not present in the 2010 ADA Standards....
-
11B-206.2.4 Spaces and elements
[2010 ADA Standards] 1....
-
11B-233.3.2 Residential dwelling units for sale
[2010 ADA Standards] 233.3.2 Residential Dwelling Units for Sale....
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
-
11B-403.3 Slope
. ◼ ETA Editor's Note The 2022 CBC Exception at 11B-403.3 is not present in the 2010 ADA Standards....
-
Section 36.406(e) Housing at a Place of Education (Section-by-Section Analysis)
standards....
-
Section 35.151(f) Housing at a place of education (Section-by-Section Analysis)
standards....
-
Section 4.26.4
• Section 4.26.4 of the 1991 Standards requires handrail gripping surfaces to have edges with a minimum radius of 1/8 inch....
-
§ 36.304(d)(2) Safe harbor
Elements in existing facilities that are not altered after [insert effective date of final rule], and that comply with the 1991 Standards, are not required to be modified in order to comply...
-
Barriers to People with Disabilities
Barriers to People with Disabilities - characteristics of spaces, elements, or services covered under the ADA Regulations or ADA Standards for New Construction that do not comply with those...
-
35. Nonacademic services
Section 104.47 establishes nondiscrimination standards for physical education and athletics counseling and placement services, and social organizations....
-
Bus boarding and alighting areas, BRT vehicles and stops/stations
ADA standards apply to buses and bus boarding and alighting areas as well as BRT vehicles and stops/stations. (DOT ADA Regulation 49 C.F.R....
-
University of Michigan Transportation Research Institute
wheelchair-occupant safety research for more than thirty years and Biosciences researchers and test engineers have been active in leading the development of wheelchair transportation safety (WTS) standards...
-
4. Assess During the Planning, Installation and Maintenance Phases
Each segment of the route should be assessed for compliance with the accessibility standards....
-
§ 36.406(c) Places of lodging.
Places of lodging subject to this part shall comply with the provisions of the 2010 Standards applicable to transient lodging, including, but not limited to, the requirements for transient...
-
§35.103(a)
Except as otherwise provided in this part, this part shall not be construed to apply a lesser standard than the standards applied under title V of the Rehabilitation Act of 1973 or the regulations...
-
§ 35.103(a) Rule of interpretation
Except as otherwise provided in this part, this part shall not be construed to apply a lesser standard than the standards applied under title V of the Rehabilitation Act of 1973 or the regulations...
-
102 Dimensions for Adults and Children
102 Dimensions for Adults and Children Section 2.1 of the 1991 Standards stated that the specifications were based upon adult dimensions and anthropometrics....
-
406.1 General
Where data connections used for input and output are provided, at least one of each type of connection shall conform to industry standard non-proprietary formats....
