For vehicles in excess of 22 feet in length, the overhead clearance between the top of the door opening and the raised lift platform, or highest point of a ramp, shall be a minimum of 68...
Search Results "Diagonal Curb Ramp"
Commonly Searched Documents
-
§ 38.25(c) Door height
-
Edge Protection
ADAAG addresses drop-offs along ramps and ramp landings but not along other portions of accessible routes or circulation paths....
-
11B-405.9.1 Reserved
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
11B-405.9.1 Reserved
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
Original research for ANSI A117.1 (1957 - 1961)
In the original research for ANSI A117.1 - 1961, American National Standard Specifications for Making Buildings and Facilities Accessible to, and Usable by, the Physically Handicapped, ramps...
-
11B-405.9.1 Reserved.
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
RESULTS OF OBJECTIVE SURFACE MEASUREMENT
The work to negotiate a ramp was linearly related to the angle of the ramp....
-
Examples of alternative ways to serve a customer when barrier removal is not feasible are:
Examples of alternative ways to serve a customer when barrier removal is not feasible are: At a dry cleaner's, providing curb-side service for a customer dropping off or picking up...
-
Handrails Requirement
Requirements for handrails in the proposed rule applied only to those provided along ramps and stairs....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or other Mobility Devices
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
C. Whether the City Can Assert an Undue Burden Defense With Respect to Existing Facilities Covered by Section 504 of the Rehabilitation Act
The Court therefore finds that no undue burden defense exists as to pedestrian rights of way, sidewalks, and curb ramps that were constructed prior to and that have not been altered since...
-
Table 2
requirements analyzed in Table 2 include: sidewalks and other pedestrian circulation paths, pedestrian street crossings, pedestrian overpasses and underpasses, pedestrian at-grade rail crossings, curb...
-
Introduction
For example, when a curb ramp extends into an access aisle at an accessible parking space, a person using a wheelchair may not be able to get out of the car or van....
- Kompan, Inc. Miram GXY926
-
§ 37.42(c)(3)
(3) Bridge plates, ramps or other appropriate devices;...
-
§ 37.42(c)(3)
(3) Bridge plates, ramps or other appropriate devices;...
-
1009.2.1 Elevators required
buildings equipped throughout with an automatic sprinkler system installed in accordance with Section 903.3.1.1 or 903.3.1.2, the elevator shall not be required on floors provided with a ramp...
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters or Other Mobility Aids
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Suggestions by Jean Tessmer
Suggestions by Jean Tessmer As published in Concrete Technology Today, April 2001, Jean Tessmer, accessibility consultant for Space Options, suggested that ramp slopes be measured with...
- Freedom Resource Center for Independent Living, Inc. - Fargo, Jamestown, Wahpeton, ND. and Fergus Falls, MN
-
DOT Response to Comments
It remains entirely consistent with the Department's ADA rule to provide ADA complementary paratransit in a curb-to-curb mode....
-
1.2.2
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
-
6b.
Is the change in level from the floor to the lift surface ramped or beveled? Yes _____ No _____...
-
Construction Specification Institute
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...