Except for light switches, where redundant controls are provided for a single element, one control in each space shall not be required to comply with Section 11B-309. 7. ...
Search Results "Side Light"
-
11B-205.1 General
-
Conventions used in this Pocket Guide
Black Text within single-outlined Box with light turquoise shading Used for DSA Advisories. ‡‡ Used at CBC Figures to signify those that...
-
Sensory Impairments
Sensory Impairments: Employers should install lighted fire strobes and other visual or vibrating alerting devices to supplement audible alarms....
-
11B-205.1 General
Except for light switches, where redundant controls are provided for a single element, one control in each space shall not be required to comply with Section 11B-309. 7....
-
Service Counters
Does that mean the full depth of the counter, from customer side to employee side? Can a split level counter be used (lower customer side, raised employee side)? ...
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
-
Text Telephones (TTYs) (Advisory Guidance)
Make sure there is a dial tone by checking for a steady light on the TTY status indicator. d....
-
Re: Service Counters
CBC 11B-904.4 does not contain any qualifying language that separates the differing requirements between the employee and customer sides of the counter because this information is contained...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
11B-705.1.2.3 Islands or cut-through medians
pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum on each side...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
11B-705.1.2.3 Islands or cut-through medians
pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum on each side...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
1. Location
Curb ramps must be placed to enable a person with a mobility disability to travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
7b.
[ADA Stds 4.13.9] Yes _____ No _____ A clear floor space on the latch side of the door (pull side) allows a person using a wheelchair or scooter to pull the door open and then...
-
4.30.6 Mounting Location and Height
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
10.3.1(5)
Signs shall be placed at frequent intervals and shall be clearly visible from within the vehicle on both sides when not obstructed by another train....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
406.4 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....