Production of the American Standard AccessPRO Toilet was discontinued, and the manufacturer says there is no replacement fixtures offered that provides ability to move laterally as...
Search Results "Seat Designation"
Filters
Commonly Searched Documents
-
Re: American Standard AccessPRO Toilet
-
Re: American Standard AccessPRO Toilet
Thanks for the heads up, Jonathan! We’ll be on the lookout for the Toto.
-
Access Board: Alternate Type Roll In Shower Stalls
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
M305.2 Transfer Supports
Possible language as modified from IEC 60601-2-52: “Transfer Supports shall be designed to withstand the forces applied during reasonably foreseeable use without creating an unacceptable...
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due...
-
11B-703.5.2 Case
Characters shall be uppercase or lowercase or a combination of both.
-
703.5.2 Case
Characters shall be uppercase or lowercase or a combination of both.
-
703.5.2 Case
Characters shall be uppercase or lowercase or a combination of both.
-
703.5.2 Case
703.5.2 Case. Characters shall be uppercase or lowercase or a combination of both.
-
A4.30.3 COLOR CONTRAST
The greatest readability is usually achieved through the use of light-colored characters or symbols on a dark background.
-
11B-703.5.2 Case
11B-703.5.2 Case. Characters shall be uppercase or lowercase or a combination of both.
-
11B-703.1.1 Plan review and inspection
11B-703.1.1 Plan review and inspection. Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or...
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due...
-
11B-703.5.2 Case
Characters shall be uppercase or lowercase or a combination of both.
-
Midmark 647 Barrier-Free® Power Podiatry Procedures Chair
section: 26" W x 6" H (66.0 cm x 15.2 cm) Foot extension: 9" (22.9 cm) Debris tray: 15.1" W x 10.6" H x 1.5" D (38.4 cm x 26.9 cm x 3.8 cm) Back Support Angle Range: 0° to 80° Seat...
-
T213.2 Priority Seats
Non-rail vehicles operated in fixed-route service shall designate at least two seats as priority seats for passengers with disabilities....
-
World Deaf Architecture
World Deaf Architecture (WDA) is specifically for professional architects and designers who are deaf, deaf-blind, or hard of hearing (designated as ‘deaf/ HOH’)....
-
Fair Housing Accessibility FIRST
Department of Housing and Urban Development (HUD) designed to promote compliance with the Fair Housing Act design and construction requirements....
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
M302.4.2 Clearance Around Base
The base of the diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of...
-
5.8.2.1 Height of Breast Platform at Time of Measurement
5.8.2.1 Height of Breast Platform at Time of Measurement Recommendation The Committee recommends measuring all knee and toe clearances when the top of the breast platform is set...
-
5.8.2.1 Height of Breast Platform At Time of Measurement
5.8.2.1 Height of Breast Platform At Time of Measurement. All knee and toe clearances should be measured when the top of the breast platform is set at 34 inches above the floor.
-
Chapter 2: Methodology
[See subsections ...]
-
M302.4.2 Clearance Around Base
The base of the equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the...
