Through further analysis, results of playground surface tests for firmness and stability were compared within surface categories and across surface categories to determine the mean, range...
Search Results "Firm Surface"
Commonly Searched Documents
-
Treatment of Data
-
4.32.4* HEIGHT OF WORK SURFACES
The tops of tables and work surfaces shall be from 28 in to 34 in (710 mm to 865 mm) from the floor or ground....
- Federal Trail Data Standards (FTDS)
-
Which surfaces are accessible to everyone?
Which surfaces are accessible to everyone? There are no surfaces that are accessible to everyone, because there is an infinite range of abilities among the population....
-
11B-224.7 Housing at a place of education
Housing at a place of education subject to this section shall comply with Sections 11B-224.1 through 11B-224.6 and 11B-806 for transient lodging guest rooms. For the purposes of the...
-
11B-224.7 Housing at a place of education
Housing at a place of education subject to this section shall comply with Sections 11B-224.1 through 11B-224.6 and 11B-806 for transient lodging guest rooms. For the purposes of the...
-
Background
Advisory information in the guidelines discusses the use of a Rotational Penetrometer to measure the firmness and stability of surfaces that are located on trails. According to U.S....
-
305.2 Floor or Ground Surfaces
Floor or ground surfaces of a clear floor or ground space shall comply with 302. Changes in level are not permitted. EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
R410.7 Height from Finish Surface
R410.7 Height from Finish Surface. Visual characters shall be 1.0 m (3.25 ft) minimum above the finish surface....
- Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.115V Informational Video
-
Accessible Routes Adjacent to the Playing Surface
Accessible Routes Adjacent to the Playing Surface If the accessible route is adjacent to the playing surface, it must not exceed 36 inches from any area where golf balls rest....
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
RESEARCH OBJECTIVES
Objectively measure the firmness and stability of the test surfaces; 3....
- Armor-Tile Tactile Systems Surface Applied Systems Installation Video
-
Purpose
trails firm and stable....
-
COMPARISON OF OBJECTIVE MEASURES AND ENERGY COSTS
COMPARISON OF OBJECTIVE MEASURES AND ENERGY COSTS Objective measures of surface firmness and stability were compared to energy costs (energy consumption, velocity, RPE and level of difficulty...
-
Energy Requirements for Different Surfaces
Energy Requirements for Different Surfaces The energy consumption results are shown in the following table and figures. Table 4....
-
(d) Outside surface at entry door
The final Guidelines also provide that at the primary entry door to a dwelling units with direct exterior access, outside landing surfaces constructed of impervious materials such as concrete...
-
Figure M4: Overview of M303 Diagnostic Equipment for Use by a Patient While Seated in a Wheelchair and M304 Diagnostic Equipment for Use by a Patient in a Standing Position (Weight Scale Example)
Where the primary use of the equipment supports more than one patient position, it must comply with the requirements for each use. The weight scale is usable by both people who are...
-
Ramp Requirements [§405]
Ramp Requirements [§405]
-
Abstract
The purpose of the longitudinal surface study was to evaluate a variety of trail surface materials, and their ability to meet proposed accessibility requirements of firmness and stability...