Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
Search Results "Existing ICT"
-
11B-404.2.10 Door and gate surfaces
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
1133B.2.3.2
The provisions of Section 1133B.2.3 shall not apply to existing buildings, except when otherwise required under conditions applicable to access for persons with disabilities....
-
Costs to Provide Accessible Pedestrian Signals and Pedestrian Pushbuttons (Section-by-Section Analysis)
estimated that pedestrian signals are newly installed or replaced at 13,095 signalized intersections on an annual basis based on the following assumptions: There are over 300,000 existing...
-
49 CFR Parts 37 and 38 -- Transportation for Individuals With Disabilities at Intercity, Commuter, and High Speed Passenger Railroad Station Platforms; Miscellaneous Amendments, Preamble
Passenger railroads must provide level-entry boarding at new or altered stations in which no track passing through the station and adjacent to platforms is shared with existing freight rail...
-
11B-206.4.10 Medical care and long-term care facilities
For existing buildings that do not have a protected accessible entrance, projects subject to Section 11B-202 are not required to provide one. ...
-
(C) NYCT’s interpretation of the ADA and DOT’s implementing regulations is too narrow.
“a means of accessible vertical access” be provided in connection with staircase or escalator alterations or additions to only those circumstances where a staircase or elevator did not exist...
-
405.2 Slope (Exception 2), 405.6 Rise (Exception)
landing configuration.44 The final rule adds exceptions to the technical requirements that permit a single ramp run with a slope not steeper than 1:10 and 36 inches maximum rise where existing...
-
Section 36.404 Alterations: Elevator Exemption (Section-By-Section Analysis and Response to Comments)
This part does not require that an existing two story building that houses the professional office of a health care provider be altered for the purpose of providing elevator access....
-
2. Accessible lavatories
As under the existing rule, this requirement would apply to new aircraft (i.e., aircraft ordered/delivered after the effective date of the rule)....
-
Retrofitting Kiosks
., retrofit 25 percent of existing kiosks or replace at least one kiosk) in each location at the airport by a certain date....
-
11B-202.3 Alterations
Where existing elements or spaces are altered, each altered element or space shall comply with the applicable requirements of Division 2, including Section 11B-202.4 _|Alterations; Path...
- Community Resources for Independence (CRI) - Allentown, Indiana, Erie, Altoona, Bradford, Clearfield, Hermitage, Lewisburg, Lewiston, McConnellsburg, Seneca, Warren, Wellsboro, and Somerset, PA
-
11B-604.4 Seats
A 3-inch (76 mm) high seat shall be permitted only in alterations where the existing fixture is less than 15 inches (381 mm) high....
-
11B-604.4 Seats
A 3-inch (76 mm) high seat shall be permitted only in alterations where the existing fixture is less than 15 inches (381 mm) high....
-
11B-407.2.1.5 Signals
Existing elevators shall not be required to comply with 407.2.1.5....
-
Paragraph (d) Availability of auditory information (Section-by-Section Analysis)
Technology exists to have this information displayed on the telephone and an installation is currently operating at the Butler plaza on the Pennsylvania Turnpike. Response....
-
407.2.2.2 Visible Signals
Existing elevators shall not be required to comply with 407.2.2.2....
-
407.2.2.1 Visible and Audible Signals
In existing elevators, a signal indicating the direction of car travel shall not be required....
-
11B-407.2.1.2 Size and shape
[2010 ADAS] EXCEPTION: Existing elevator call buttons shall not be required to comply with 407.2.1.2....
-
5. CONSTRUCTION TOLERANCES
TOLERANCES: While it is always advisable to avoid design requirements that are at or near dimensional thresholds, construction tolerances may be used when evaluating the compliance of existing...
-
608.7 Thresholds
EXCEPTION: A threshold 2 inches (51 mm) high maximum shall be permitted in transfer type shower compartments in existing facilities where provision of a 1/2 inch (13 mm) high threshold would...
-
Reasons for issuing proposed accessibility guidelines
The proposed guidelines are developed specifically for pedestrian facilities in the public right-of-way and address conditions and constraints that exist in the public right-of-way....
-
407.2.2.2 Visible Signals
Existing elevators shall not be required to comply with 407.2.2.2....