The slopes of the planned finished grade measured between the entrance and all vehicular or pedestrian arrival points within 50 feet (15 240 mm) of the planned entrance also exceed 15 percent...
Search Results "Non-Glare Finish"
Commonly Searched Documents
-
TEST NO. 1 – INDIVIDUAL BUILDING TEST
-
1136A.2 Switch and control heights
shall be located no more than 48 inches (1219 mm) measured from the top of the outlet box nor less than 15 inches (381 mm) measured from the bottom of the outlet box to the level of the finished...
-
Q2.) What are the types of “field conditions” that were anticipated where the advisory says “tolerances recognized by this provision include those for field conditions”?
And a concrete finisher clearly cannot guarantee that the slope of a concrete curb ramp will be consistently 8.33% across its entire surface. ...
-
R410.6 Character Height
Table R410.6 Visual Character Height Height to Finish Surface from Baseline of Character Horizontal Viewing Distance Minimum Character Height 1.0 m (3.3...
-
Deferred Maintenance
Schedule with completion dates for improvements that will take more than 1 year to finish....
-
TEST NO. 1 – INDIVIDUAL BUILDING TEST
The slopes of the planned finished grade measured between the entrance and all vehicular or pedestrian arrival points within 50 feet (15 240 mm) of the planned entrance also exceed 15 percent...
-
1136A.2 Switch and control heights
shall be located no more than 48 inches (1219 mm) measured from the top of the outlet box nor less than 15 inches (381 mm) measured from the bottom of the outlet box to the level of the finished...
-
11B-233.3.1.2.6.2 Test number one, individual building test
The slopes of the planned finished grade measured between the entrance and all vehicular or pedestrian arrival points within 50 feet (15,240 mm) of the planned entrance also exceed 15 percent...
-
1136A.2 Switch and control heights
shall be located no more than 48 inches (1219 mm) measured from the top of the outlet box nor less than 15 inches (381 mm) measured from the bottom of the outlet box to the level of the finished...
-
TEST NO. 1 – INDIVIDUAL BUILDING TEST
measured between the planned entrance and all vehicular or pedestrian arrival points within 50 feet (15 240 mm) of the planned entrance exceed 15 percent; and The slopes of the planned finished...
- Bradley Recessed Dual Roll Toilet Tissue Dispenser 5124
-
Mariana Figueiro, Ph.D. 24-hr Lighting Schemes for Older Adults and Persons with Low Vision
Distribution And in terms of distribution, we talked a lot about glare, and a [visual system] is very sensitive to how you provide the light....
- Viking K-1600-EHFA Elevator Phone with Built-in Dialer and Digital Announcer
- Stanley FBB 266 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
- Stanley FBB 268 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
- Stanley FBB 264 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
- Stanley FBB 269 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
-
Employee Work Area - Reasoning Behind Code?
I understand how approach, entry & exit helps to facilitate future individual accommodations and provides access for non-employees who would not be covered under Title I (ie inspectors...
- Viking E-1600-45A-EWP Emergency Phones with Built-in Auto Dialer and Digital Announcer with Weather Protection
- AJW Architectural Products U646 Series Lever Operated Roll Towel Dispenser & Waste Receptacle Combination - Recessed
-
II. Recommendations of Diagnostic Imaging Equipment Manufacturers on Transfer Surface Low Height
While it is ideal for transfer surfaces to be at the same height as the seat heights of mobility devices, there is evidence that non-level independent transfers are also feasible....
-
F. Paperwork Reduction Act
Section 602.4: The estimated response time assumes that development of accessible non-electronic support documentation in alternate formats (e.g., braille, large print) will take 25 hours...
-
Section 35.151(g) Assembly Areas (Section-by-Section Analysis)
These platforms cover one or more rows of non-wheelchair seating. ...
-
4. Benefits of the Proposed Rule
due to use of internationally recognized, industry-driven standards Potential cost savings to manufacturers of telecommunications and CPE, state and local governments, and non-profit...