entity. (2) The type of auxiliary aid or service necessary to ensure effective communication will vary in accordance with the method of communication used by the individual; the nature, length...
Search Results "Full Length Mirror"
Commonly Searched Documents
-
Primary Consideration
-
11B-604.5 Grab bars
Reinforcement must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length,...
-
Check-Out Aisles [7.3]
Design* Minimum Accessible of Each Design 1‒4 1 5‒8 2 9‒15 3 0ver 15 3 (+ 20% of total above 15) *e.g. belt length...
-
A4.17.3 Size and Arrangement
Since the stall is primarily intended for use by persons using canes, crutches and walkers, rather than wheelchairs, the length of the stall could be conventional....
-
Suggested accessibility guidelines for exterior concrete surfaces
The deviation from slope or plane of formed surfaces over 10 feet (3 m) is ± 0.3% of length. This is approximately 3/8 inch in 10 feet (10 mm in 3 m)....
-
Positioning Supports Considered
., length, height above the patient support surface, location) to ensure their effectiveness?...
-
11B-403.5.1 Clear width
The clear width shall be permitted to be reduced to 32 inches (813 mm) minimum for a length of 24 inches (610 mm) maximum provided that reduced width segments are separated by segments that...
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
-
11B-403.5.1 Clear width
Exceptions: The clear width shall be permitted to be reduced to 32 inches (813 mm) minimum for a length of 24 inches (610 mm) maximum provided that reduced width segments are separated...
-
5.3.1 Permitted Obstructions to Transfer Sides for M301 and M302
The 3-inch maximum gap applies to two sides of medical diagnostic equipment with a rectangular shape, the long length (width) and the short length (depth), where the transfer surface is...
-
4. What factors should a public school district consider in determining what auxiliary aids or services are necessary to afford qualified students with disabilities an equal opportunity to participate in, and enjoy the benefits of, the public school’s services, programs, or activities?
determination of what auxiliary aids or services will provide effective communication must be made on a case‐by‐case basis, considering the communication used by the student, the nature, length...
-
Test Courses & Surfaces
This “access route” was 574.2 ft (175.0 m) in length, and included two 137 ft (41.8 m) sections with grades of 4% to 5% (one uphill, one downhill), and two 30-foot (9.1 m) ramps with grades...
- Magnuson Group WH Hanger Style Wall Rack
- Rockwood Manufacturing Company BFRC24 Vertical Rod Cover
- Rockwood Manufacturing Vertical Rod Cover BFRC12
- Mockett DH401-BB Slim Barrel Door Handle Back to Back
- Bobrick Surface-Mounted Toilet Tissue Dispenser with Hood B-6699
- Deltrex J109 Jumbo Push Plate Switch
- Delta Adjustable Grab Bar 2-Setting Hand Shower 52001-UF
- Delta Adjustable Grab Bar 2-Setting Hand Shower 52003-UF
-
Medical Examinations
When a worker wishes to return to work after absence due to accident or illness, s/he can only be required to have a "job-related" medical examination, not a full physical exam, as a condition...
-
9.5 Do the ADA's Pre-Employment Inquiry and Confidentiality Restrictions Prevent an Employer from Filing Second Injury Fund Claims?
Without a second injury fund, if a worker suffered increased disability from a work-related injury because of a pre-existing condition, the employer would have to pay the full cost....
-
Maximum Leave Policies
An employee uses the full 12 weeks of FMLA leave for her disability but still needs five additional weeks of leave....
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...