Search Results "Fixed Assembly Seating"

• Federal Documents > Technical Assistance > Guidance on the 2010 ADA Standards for Accessible Design
  Plan 2B: 13-Foot Wide Accessible Guest Room

  Features include an alternate roll-in shower with a seat, comparable vanity, wardrobe, and door connecting to adjacent guest room. Furnishings include two beds.  ...

• Research and History > Research Documents > Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
  Results

  [See subsections ...]

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Transfer Surface (M301.2 and M302.2)

  Depending on the configuration of the equipment, the transfer surface may coincide with the seat area of an examination chair, or occupy only a portion of an examination table or imaging...

• Rulemaking Process Documents > NPRMS > 28 CFR Part 36 Nondiscrimination on the Basis of Disability by Public Accommodations and in Commercial Facilities NPRM (2008 Title III NPRM)
  § 36.302(f)(3) Identification of accessible seating

  (3) Identification of accessible seating. ...

• State and Local Documents > Codes and Standards > 2022 California Standards
  AMUSEMENT RIDE SEAT

  [DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....

• Legal Documents > SCOTT JOHNSON v. STARBUCKS CORPORATION - AMICUS BRIEF
  B. Question 2: Section 904.4.1 and Clear Counter Space

  Moreover, the ADA Standards “cover fixed or built-in elements of buildings, structures, site improvements, and pedestrian routes or vehicular ways located on a site." 28 C.F.R. § 36.406(...

• Federal Documents > Technical Assistance > Guidance on the 2010 ADA Standards for Accessible Design
  806 Transient Lodging Guest Rooms

  806 Transient Lodging Guest Rooms In the NPRM, the Department included floor plans showing examples of accessible guest rooms and bathrooms designs with mobility features to...

• Federal Documents > Regulations > 24 CFR Part 100—Fair Housing Accessibility Guidelines
  7(2)(b)(vii)

  or on the accessible level of a covered multistory unit, and measures a nominal 36 x 36, the shower stall must have reinforcing to allow for installation of an optional wall hung bench seat...

• Products and Additional Resources > Products
  Bradley Fixed Tilt Mirror 740
  

  Fixed tilt mirror Satin finish stainless steel frame Standard 6° angle to wall Welded corners Standard sizes available BradEX...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Head and Back Support (M301.3.3 and M302.3.3)

  Where diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated position can be adjusted to reclined positions...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  3. Exception to Ramp Running Slope

  The Access Board agrees with the MDE Advisory Committee that additional allowances in the slope of ramp runs of diagnostic equipment used by patients seated in a wheelchair with raised platforms...

• Webinars, Videos, and Training > Official Technical Assistance
  Access Board: Transfer Type Shower Compartments
  

  This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...

• State and Local Documents > Codes and Standards > 2022 California Standards
  1018.5 Aisles in other than assembly spaces and Groups B and M

  In other than rooms or spaces used for assembly purposes and Group B and M occupancies, the minimum clear aisle capacity shall be determined by Section 1005.1 for the occupant load served...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M302.4.1 Clearance in Base

  The base of the diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M303.3.3 Ramped (Section-by-Section Analysis)

  The MDE NPRM proposed that for equipment with a change in level at the entry of a wheelchair space, level changes greater than ½ inch high would be required to be ramped and comply...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.1 Ramped Entry Slope Recommendations

  5.8.1.2.1 Ramped Entry Slope Recommendations The Committee recommends that raised platforms have a ramp with slopes that do not exceed the following: At 0 to 1½ inches, the...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms

  5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height

  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height. Edge protection is not required on platforms 1 ½ inches or less in height.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms

  5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms Recommendations Description: Entry to wheelchair spaces on raised surfaces greater than ¼ inch in height requires a...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations

  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations The Committee recommends a two-inch high edge protection on the back of the...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.1 Ramped Entry Slope

  5.8.1.2.1 Ramped Entry Slope. Raised platforms should have a ramp with slopes that do not exceed the following: Rise 0 to 1 ½ inches – 1:2 Slope Rise >1 ½ to 2 ½ inches – 1:8...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides

  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides. A minimum 2 inch high edge protection must be provided on both sides of the platform for double ramped entry...