Entrances (slides 3 and 4) Additional comments: Need better signage at entrances Handle locations should be consistent Ramps (slide 5) Route of Travel...
Search Results "Vehicle Ramp"
-
Jeanne Halloin, IES. Existing Standards and Design Guidance
-
C. Boarding and Deplaning Assistance
[Sec. 382.39(a)] The type of assistance you must offer includes, as needed, services personnel and the use of wheelchairs, ramps, or mechanical lifts....
-
Figure 505.6 Horizontal Projections Below Gripping Surface – Drawing from the U.S. Access Board
-
Figure 505.4 Handrail Height – Drawing from the U.S. Access Board
-
Designing Sidewalks and Trails for Access, Part II of II: Best Practices Design Guide
This guidebook is the second part of a two-phase project focused on designing sidewalks and trails for access. It was created to provide planners, designers, and transportation...
-
Designing Sidewalks and Trails for Access, Part I of II: Review of Existing Guidelines and Practices
Sidewalks and trails serve as critical links in the transportation network by providing pedestrian access to commercial districts, schools, businesses, government offices, and...
-
4.6.3* PARKING SPACES
Parked vehicle overhangs shall not reduce the clear width of an accessible circulation route....
-
Accessible - Changes in Level
Changes in level greater than 1/2" shall be accomplished by means of a ramp. The maximum slope of a ramp in new construction shall be no greater than 1;12....
-
Attachment A: Violations Identified in the United States' Letter of Findings (Sept. 29, 2014)
[See subsections ...]
-
At what types of property/sites must the ADA requirements be met?
RESPONSE: EVCS installed at public buildings, public accommodations, commercial facilities and public housing are required to comply with the accessibility requirements in CBC...
-
T208 Passenger Access Routes
[See subsections ...]
-
CHAPTER 6: WHEELCHAIR SPACES AND SECUREMENT SYSTEMS
[See subsections ...]
-
T605 Seat Belts and Shoulder Belts
[See subsections ...]
-
§ 38.107(a)(4)
(4) Faucets and flush controls shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist. The force required to activate controls shall...
-
IV.B.2.
2. Characters on signs required by paragraph IV.B.1 of this appendix shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10,...
-
§ 37.42(c)
(c) For new or altered stations serving commuter, intercity, or high-speed rail lines or systems, in which track passing through the station and adjacent to platforms is shared with...
-
§ 37.42(c)
(c) For new or altered stations serving commuter, intercity, or high-speed rail lines or systems, in which track passing through the station and adjacent to platforms is shared with...
-
1009.8 Two-way communication
Two-way communication systems are not required on floors provided with ramps conforming to the provisions of Section 1012....
-
11B-406.5.1 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-406.5.1 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-406.5.1 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-503.4 Floor and ground surfaces
Vehicle pull-up spaces and access aisles serving them shall comply with Section 11B-302. Access aisles shall be at the same level as the vehicle pull-up space they serve....
-
1009.8 Two-way communication
Two-way communication systems are not required on floors provided with ramps conforming to the provisions of Section 1012....
-
M303.3.3.1 Running Slope
Ramp runs shall have a running slope not steeper than 1:12....
