Electronic measuring technology / Two digital displays / Audible inclination guide / IP 65 Dust and Waterproof / Removable shock-absorbing end caps with anti-slip wall...
Search Results "Hybrid Surface System"
Commonly Searched Documents
- Stabila, Inc. Tech Digital Electronic Level Type 196-2
- Stabila, Inc. Magnetic Tech Digital Electronic Level Type 96M-2
-
(2) Transfer Surface Location for Diagnostic Equipment Used in the Seated Position
Transfer onto these types of diagnostic equipment must be made from either long side, similar to the side transfer surface described above....
-
§ 38.125(b)(6) Platform surface
(6) Platform surface. The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
-
Check-Out Aisles [7.3]
Writing surfaces must be 36 inches maximum from the floor....
-
11B-708.2 Audible and visual indicators
The system shall provide both audible and visual signals. [2010 ADAS] Advisory 708.2 Audible and Visual Indicators....
- Williams Sound - PPA T45NET Introduction
- UltraPlay Getting Started Installation Video
- Ronick Matting Systems BaseMat 300 Entrance Floor Mat
-
§ 38.173(c)
(c) In stations where open platforms are not protected by platform screens, a suitable device or system shall be provided to prevent, deter or warn individuals from stepping off the platform...
-
Poured in Place Rubber
The surface cost for PIP ranged from $6.59/sq. ft. to $19.80/sq. ft. ...
-
Assumptions
Assumptions Two industry standard specifications are used to determine the safety and accessibility of each surface: ASTM F1292‒99/04 Standard Specification for Impact Attenuation of...
-
The Brewer Company, LLC
Company, LLC Minority Report The Brewer Company, LLC 01-Oct-2013 Final Report Medical Diagnostic Equipment Accessibility Standards Advisory Committee Section 5.1.3 Transfer Surface...
-
11B-215.3 Employee work areas
Where employee work areas have audible alarm coverage, the wiring system shall be designed so that visible alarms complying with Chapter 9, Section 907.5.2.3.2 can be integrated into the...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
No public comments were submitted on this issue, but the MDE Advisory Committee voiced concern about surface hazards stating, “gripping surface configurations must provide an effective and...
-
15. Q: When would an officer use an assistive listening device as a communication aid?
A: Assistive listening systems and devices receive and amplify sound and are used for communicating in a group setting with individuals who are hard of hearing....
-
11B-215.3 Employee work areas
Where employee work areas have audible alarm coverage, the wiring system shall be designed so that visible alarms complying with Chapter 9, Section 907.5.2.3.1 Exception can be integrated...
-
11B-215.3 Employee work areas
Where employee work areas have audible alarm coverage, the wiring system shall be designed so that visible alarms complying with Chapter 9, Section 907.5.2.3.1 Exception can be integrated...
-
405.3 Cross Slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
405.3 Cross Slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
5.1.1 Transfer Surface Height Adjustability
5.1.1 Transfer Surface Height Adjustability. The transfer surface should have an adjustable height in small virtually continuous increments....
-
Signage
Signage Where assistive listening systems are required, signs must be provided to notify patrons of ALS availability....
-
T213 Seats
The 2010 NPRM proposed that non-rail vehicles operating in fixed route systems be required to designate at least two seats as priority seats for passengers with disabilities....
-
4.30.7(4)
(4) Assistive Listening Systems....