(1) Size and clearances. Shower stall size and clear floor space shall comply with either Fig. 35(a) or (b). The shower stall in Fig. 35(a) shall be 36 in by 36 in (915 mm by 915 mm)....
Search Results "Hinge Side Clearance"
-
4.34.5.5(1) Size and clearances
-
5.1 Transfer Surface Height
5.1 Transfer Surface Height
-
5.1.4 Transfer Surface Height Measurement
5.1.4 Transfer Surface Height Measurement. The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of...
-
1003.3.2 Boarding Pier Clearances
Advisory 1003.3.2 Boarding Pier Clearances. These requirements do not establish a minimum length for accessible boarding piers at boat launch ramps....
-
Access Board: Multi User Toilet Room Layout
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
608.2 Size and Clearances for Shower Compartments
Shower compartments shall have sizes and clearances complying with 608.2....
-
608.2 Size and Clearances for Shower Compartments
Shower compartments shall have sizes and clearances complying with 608.2....
-
Attachment H: Modifications to Altered Facilities
Attachment H: Modifications to Altered Facilities
-
1003.3.1 Boat Slip Clearance
Advisory 1003.3.1 Boat Slip Clearance Exception 3....
-
11B-608.2 Size and clearances for shower compartments
11B-608.2 Size and clearances for shower compartments. Shower compartments shall have sizes and clearances complying with Section 11B-608.2....
-
Additional benefits of water closet clearance standards
The standards requiring sufficient space in single-user toilet rooms for a wheelchair user to effect a side or parallel transfer are among the most costly (in monetary terms) of the new...
-
Additional benefits of water closet clearance standards
The standards requiring sufficient space in single-user toilet rooms for a wheelchair user to effect a side or parallel transfer are among the most costly (in monetary terms) of the new...
-
7(1) Usable kitchens
(1) Usable kitchens. Usable kitchens would meet section 100.205(c)(3)(iv) if:
-
224 Transient Lodging Guest Rooms
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s...
-
Low Energy Doors and Gates [§404.3]
Low Energy Doors and Gates [§404.3] Low energy doors and gates usually require activation by the user through a push plate or control and are often used in moderate traffic...
-
Bradley Recessed Hinged Hood Stacking Rolls Toilet Tissue Dispenser 5127
Recessed Hinged Hood Non-Controlled Delivery Bright Polished Stainless Steel Dual Roll BradEX...
-
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impact Performance Phase 2: Final Report REPORT PREPARED FOR: U.S ACCESS BOARD, WASHINGTON,...
-
1003.3.2 Boarding Pier Clearances
Advisory 1003.3.2 Boarding Pier Clearances. These requirements do not establish a minimum length for accessible boarding piers at boat launch ramps....
-
Bradley Recessed Hinged Hood Dual Roll Toilet Tissue Dispenser 5123
Recessed Hinged Hood Non-Controlled Delivery Bright polished Stainless Steel Dual Roll (For Single Roll See Model 5103)...
-
Access Board: Accessible Van Parking
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in it's entirety on the Access Board's website here:...
-
Gamco Partition Mounted Dual-Sided Multi-Roll Toilet Tissue Dispenser - TTD-7
Mounts centered through toilet partitions, 1/2"-2" (12-50mm) thick; used from both sides....
-
Re: DSA Drawing 11B-406-1C Curb Ramp Adjoining a Parking Access Aisle next to a Curb and Gutter (2016 CBC)
This drawing should show that the gutter is not included in the required min 18’ depth. The dashed lines don’t spell it out clearly enough to me.
