per foot value for straight propulsion and for turning less than the average work per foot values for straight propulsion and for turning, respectively, on a hard, smooth surface with a grade...
Search Results "Finished Grade"
-
[2010 ADAS] 105.2.3 ASTM
-
3. Exception to Ramp Running Slope
A ramp in the built environment to which this exception applies may use a 1:2 grade slope on a short rise ramp....
-
Table 3
pedestrian street crossings at roundabouts, detectable warning surfaces on curb ramps and blended transitions at pedestrian street crossings, detectable warning surfaces on pedestrian at-grade...
-
ASTM
per foot value for straight propulsion and for turning less than the average work per foot values for straight propulsion and for turning, respectively, on a hard, smooth surface with a grade...
-
Section 1630.2(o) Reasonable Accommodation
An employer may reassign an individual to a lower graded position if there are no accommodations that would enable the employee to remain in the current position and there are no vacant...
- Roadtech Manufacturing Retractable Cone Bar Barricades and Barriers
- Midmark 647 Barrier-Free® Power Podiatry Procedures Chair
- Georgia-Pacific SofPull® High-Capacity Automated Roll Towel Dispenser
- Yale 51 Series Industrial Door Closer
- Viking E-1600-45A Emergency Phone
-
Reach Ranges
The 2010 Standards, at section 308.3, lower that maximum height to 48 inches above the finish floor or ground....
-
Amenities
There shall be no projections into the required clear opening width lower than 34 inches and 80 inches above the finish floor or ground shall not exceed 4 inches....
-
A. Question 1: Applicability of Section 904.4.1’s Exception
Section 904.4.1 and its exception both require that a sales or service counter be “36 inches (915 mm) high maximum above the finish floor,” and Section 904.4.1 further requires that a sales...
-
How is slip resistance measured?
of the static coefficient of friction provides a reasonable approximation of the slip resistance of most surfaces and is the method most appropriate for evaluating surface materials and finishes...
-
Can parking signage height be considered a "safe harbor"?
Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign.” ...
-
III. Results of the Study
NORTHEAST REGION MD Woodchips with an epoxy product No Data MA Dense grade gravel Over time the larger (3/4" - 1") stones...
-
Winning the War: Bamboo and Invasive Removal with the X500
Grading and Replanting Once the invasives are removed, the ground is often left churned up and uneven....
-
Structural Impracticability (Preamble, Section-by-Section Analysis)
This exception to accessibility requirements should not be applied to situations in which a facility is located in ‘‘hilly’’ terrain or on a plot of land upon which there are steep grades...
-
Where must the wheelchair symbol be posted?
evaluated for accessibility, post the following information in addition to the standard message with the trail name, number, destination, and distance: Typical and maximum trail grade...
-
Sweep Width
ft).(2) Additionally it recommends (pp. 35-36) a minimum width of 3 m (10 ft) for a two-way shared use path (and a wider path is desirable where there is substantial use and/or a steep grade...
-
Structural Impracticability (Section-By-Section Analysis and Response to Comments)
This exception to accessibility requirements should not be applied to situations in which a facility is located in "hilly'' terrain or on a plot of land upon which there are steep grades...
- Midmark 625 Barrier-Free® Power Examination Table
- Automatic Curtain Ltd. CL-920C4 Single Track Automatic Curtain System
- Inpro ENDURANT® Velox™ Trench Receptor