Handpumps are vital to drawing water in campgrounds where the water system isn't pressurized, but operating the long handle of the traditional pump requires more force and a longer reach...
Search Results "Traditional Seating"
-
What if the Guidelines Appear To Conflict With Each Other?
-
Skateboards
Traditional skateboards are under 84 cm (33 inches) long, but "long boards" over 89 cm (35 inches) are used for "cruising."...
-
MEASUREMENT TECHNIQUE
is measured between the perineal cutout and the hinge point at the back of the seat....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
§ 35.138(g) Ticket prices
The price of tickets for accessible seating shall not be set higher than for tickets to seating located in the same seating section for the same event. ...
-
11B-608.10 Soap dish
Where a soap dish is provided, it shall be located on the control wall at 40 inches (1016 mm) maximum above the shower floor, and within the reach limits from the seat....
-
11B-608.10 Soap dish
Where a soap dish is provided, it shall be located on the control wall at 40 inches (1016 mm) maximum above the shower floor, and within the reach limits from the seat....
-
II-5.2000 Methods for providing program accessibility.
ILLUSTRATION 4: A municipal performing arts center provides seating at two prices -- inexpensive balcony seats and more expensive orchestra seats....
-
11B-206.2.5 Restaurants, cafeterias, banquet facilities and bars
accessible route between stories, an accessible route shall not be required to a mezzanine dining area where the mezzanine contains less than 25 percent of the total combined area for seating...
-
11B-206.2.5 Restaurants, cafeterias, banquet facilities and bars
accessible route between stories, an accessible route shall not be required to a mezzanine dining area where the mezzanine contains less than 25 percent of the total combined area for seating...
-
General: ADA Standard Section 405.1
Section 405.1 of the ADA Standards covers information in the current ADA Standards for ramps.
-
Size: ADA Standard Section 903.3
Benches shall have seats that are 42 inches (1065 mm) long minimum and 20 inches (510 mm) deep minimum and 24 inches (610 mm) deep maximum....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests. ...
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
Structural Strength: ADA Standard Section 903.6
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Ticketing (Assembly areas, not parking.)
People purchasing a ticket for an accessible seat may purchase up to three additional seats for their companions in the same row and these seats must be contiguous with the accessible seat...
-
10) Assembly areas
10) Assembly areas ADAAG: * Wheelchair seating: Requirements triggered in any assembly area with fixed seating that seats four or more people....
-
A4.33.3 Placement of Wheelchair Locations
Building/life safety codes set minimum distances between rows of fixed seats with consideration of the number of seats in a row, the exit aisle width and arrangement, and the location of...
-
University of Michigan Transportation Research Institute
UMTRI’s Biosciences Group conducts sled-impact tests of wheelchairs, wheelchair seating systems, and wheelchair tiedowns and occupant-restraint systems (WTORS) to evaluate their frontal-...
-
221 Assembly Areas
seating (221.5)....
-
407.3.2 Alphabetic Keys (Section-by-Section Analysis)
407.3.2 Alphabetic Keys (Section-by-Section Analysis) This section proposes to require alphabetic keys, where provided, to be arranged in a traditional QWERTY layout, with tactilely distinct...
