Elevator car leveling shall comply with 407.4.4....
Search Results "Elevated Play Component"
Commonly Searched Documents
-
408.4.4 Leveling
-
11B-408.4.4 Leveling
Elevator car leveling shall comply with Section 11B-407.4.4....
-
11B-408.4.4 Leveling
Elevator car leveling shall comply with Section 11B-407.4.4....
-
Elevator Exemption (Preamble, Section-by-Section Analysis)
Elevator Exemption Section 36.401(d) implements the ‘‘elevator exemption’’ for new construction in section 303(b) of the ADA....
-
409.3.1 Power Operation
Elevator car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19 (1997 or 2002 edition) (incorporated by reference, see "Referenced Standards" in...
-
11B-408.4.2 Floor surfaces
Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303....
-
408.4.2 Floor Surfaces
Floor surfaces in elevator cars shall comply with 302 and 303....
-
11B-408.4.2 Floor surfaces
Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303....
-
11B-408.4.2 Floor surfaces
Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303....
-
Sec.36.401(d) Elevator exemption
(d) Elevator exemption....
- Unity Surfacing Systems Soft-Land Rubberized Safety Surfacing
-
Can a more recent edition of the ASME A17.1 Safety Code for Elevators and Escalators (or the ASME A18.1 Safety Standard for Platform Lifts and Stairway Chairlifts) be used instead of the editions referenced in the Standards?
The specific editions of the ASME A17.1 and ASME A18.1 codes referenced by the ADA Standards are to be followed (although the Access Board intends to update references to keep them...
-
(1) Site impracticality
The final Guidelines provide that covered multifamily dwellings with elevators shall be designed and constructed to provide at least one accessible entrance on an accessible route regardless...
-
407.1 General
Elevators shall comply with 407 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1). They shall be passenger elevators as classified by ASME A17.1....
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
dwelling units, in a single building with one common (lobby) entrance, located on a site with difficult terrain conditions or unusual characteristics: All ground floor units in non-elevator...
-
11B-233.3.1.2 Residential dwelling units with adaptable features
ETA Editor's Note This section of the 2019 California Building Code was amended by the Division of the State Architect. The requirements in this section were previously found in...
-
4.10.13* Car Position Indicators
In elevator cars, a visual car position indicator shall be provided above the car control panel or over the door to show the position of the elevator in the hoistway....
-
4.10.13* CAR POSITION INDICATORS
In elevator cars, a visual car position indicator shall be provided above the car control panel or over the door to show the position of the elevator in the hoistway....
-
IX. New Construction
Elevators are not required in facilities under three stories or with fewer than 3,000 square feet per floor, unless the building is a shopping center, shopping mall, professional office...
-
1007.2.1 Buildings with four or more stories
In buildings where a required accessible floor is four or more stories above or below a level of exit discharge, at least one required accessible means of egress shall be an elevator complying...
-
1003.2.13.1.1 Buildings with four or more stories
In buildings where a required accessible floor is four or more stories above or below a level of exit discharge, at least one required accessible means of egress shall be an elevator complying...
-
Elevator Exemption (Section-By-Section Analysis and Response to Comments)
Elevator Exemption (Section-By-Section Analysis and Response to Comments) Section 36.401(d) implements the "elevator exemption'' for new construction in section 303(b) of the ADA....
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...