transportation if carrying the wheelchair and its occupant would be inconsistent with legitimate safety requirements, as when, for example, the wheelchair is so large it would block an aisle...
Search Results "Cross-Aisle"
-
Is a transportation operator required to carry these “overweight” wheelchairs?
-
4.4.1* GENERAL
) with their leading edges between 27 in and 80 in (685 mm and 2030 mm) above the finished floor shall protrude no more than 4 in (100 mm) into walks, halls, corridors, passageways, or aisles...
-
210 Stairways
In assembly areas, aisle stairs shall not be required to comply with 504. 4. Stairs that connect play components shall not be required to comply with 504....
-
221.2.3.1 Horizontal Dispersion
Intermediate aisles shall be included in determining the total row length....
-
1004.1 Clear Floor Space
To optimize space use, designers should carefully consider layout options such as connecting ends of the row and center aisle spaces....
-
221.2.3.1 Horizontal Dispersion
Intermediate aisles shall be included in determining the total row length....
-
1015.3 Height
On stairways and stepped aisles, from the line connecting the leading edges of the tread nosings. On ramps and ramped aisles, from the ramp surface at the guard....
-
502.5 Vertical Clearance
Parking spaces for vans and access aisles and vehicular routes serving them shall provide a vertical clearance of 98 inches (2490 mm) minimum....
-
11B-226.1 General
Check writing surfaces provided at check-out aisles not required to comply with Section 11B-904.3 shall not be required to comply with Section 11B-902. Advisory 11B-226.1 General....
- Floating Trail Bridges and Docks
-
1016.5 Obstacles
Where possible, obstacles that cross the full width of outdoor recreation access routes should be separated by a distance of 48 inches (1220 mm) minimum....
-
Building Entrance
Doors may not have high thresholds that impede voters who use wheelchairs or other mobility devices in crossing the threshold....
-
Handrails Requirement
The handrail requirements in section 505 address specifications for continuity, height, clearance, gripping surface, cross section, fittings, and extensions....
-
Trailhead Signs
the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and maximum running slope; and typical and maximum cross...
-
1016.5 Obstacles
Where possible, obstacles that cross the full width of outdoor recreation access routes should be separated by a distance of 48 inches (1220 mm) minimum....
-
§ 38.159(c)(8) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches (32 mm) and 11/2 inches (38 mm) or shall provide an equivalent grasping surface, and have eased edges with corner radii...
-
Accessible Routes from Site Arrival Points and Within Sites
The 1991 Standards require that curb ramps be provided wherever an accessible route crosses a curb....
-
Installation of Aggregate Surfaces at Bradford Woods
Bradford Woods conformed to the following protocol: Prior to installing the crushed rock (aggregate) surfacing material, the trail bed shall be shaped to reflect the same linear grade and cross...
-
11B-403.3 Slope
The cross slope of walking surfaces shall not be steeper than 1:48....
- Armor-Tile Tactile Systems Modular Paver Systems
- Tork Elevation® Matic® Hand Towel Roll Dispenser with Intuition® Sensor, Black
- Disability Resource Center (dRC) - Fredericksburg, VA
-
4. Assess During the Planning, Installation and Maintenance Phases
A digital level can be used to measure the running slope and cross slope....
-
Key Differences Between Routes
Exterior accessible routes may include accessible parking space access aisles, curb ramps, crosswalks at vehicular ways, walks, ramps, and platform lifts....