Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
Search Results "Side Light"
Filters
Commonly Searched Documents
-
11B-402.2 Components
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
-
Imaging bed
A component of diagnostic scanning equipment that accommodates patients in supine, prone, or side-lying positions....
-
M18
Is the flush valve located on the side adjacent to the lavatory? [ADA Standards § 4.16.5] Yes No...
-
4.7.3 Width
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
4.7.3 WIDTH
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
M304.3 Standing Supports
Standing supports shall be provided on each side of the standing surface and shall comply with M305.3....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm) minimum...
-
Alarm Clock Pro (Stand-alone alarm clock) (BE1370)
The Alarm clock Pro wakes the user with a loud Sound alarm, Flashing lights and Vibrations from the Bed-shaker when it’s time to get up....
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
1. Location
Curb ramps must be placed to enable a person with a mobility disability to travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
406.4 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
7b.
[ADA Stds 4.13.9] Yes _____ No _____ A clear floor space on the latch side of the door (pull side) allows a person using a wheelchair or scooter to pull the door open and then...
-
4.30.6 Mounting Location and Height
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
10.3.1(5)
Signs shall be placed at frequent intervals and shall be clearly visible from within the vehicle on both sides when not obstructed by another train....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
Text Telephones (TTYs) (Advisory Guidance)
Make sure there is a dial tone by checking for a steady light on the TTY status indicator. d....
-
11B-205.1 General
Except for light switches, where redundant controls are provided for a single element, one control in each space shall not be required to comply with Section 11B-309. 7. ...
-
Conventions used in this Pocket Guide
Black Text within single-outlined Box with light turquoise shading Used for DSA Advisories. ‡‡ Used at CBC Figures to signify those that...
-
Sensory Impairments
Sensory Impairments: Employers should install lighted fire strobes and other visual or vibrating alerting devices to supplement audible alarms....
-
11B-205.1 General
Except for light switches, where redundant controls are provided for a single element, one control in each space shall not be required to comply with Section 11B-309. 7....
