The low transfer position height, Item A of M302.2.1, shall cease to have effect on [Insert date 5 years after date of publication in the Federal Register]. [sic]
Search Results "Seating Plan"
-
M302.2.2 Sunset
-
M302.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A. A low transfer position...
-
M302.2.2 Sunset Provision (Section-by-Section Analysis)
As discussed in Section IV.B.1.a. (Significant Changes – Transfer Surface Adjustability), this is a new provision added to the final rule in conjunction with the new requirement of a...
-
M305.2.3 Fittings
M305.2.3 Fittings Proposed requirement: Transfer supports shall not rotate within their fittings • Sub-Committee Recommendation: Transfer supports shall not rotate within...
-
Overhead Lifts
The technical criteria do not address overhead lifts that are usually mounted on the ceiling and operate on tracks suspended over the diagnostic equipment because the configuration...
-
Clearance in Base (M301.4.1 and M302.4.1)
Clearance in the base of the equipment allows the legs of a portable floor lift to fit under the base of the equipment. The clearance can be an open area between the supporting posts...
- Figure 608.5.3 Alternate Roll-In Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
Practice Your Plan
To be prepared you need to test your plan....
-
Emergency Travel Safety Tips for Overnight Stays
Edition 1 – October 2017 By June Isaacson Kailes This document was made possible with support from: Grant to North Carolina Emergency Management from The North...
-
12206(a) Plan for Assistance
(a) Plan for Assistance. --...
-
12206(a) Plan for assistance
(a) Plan for assistance...
-
How to Measure Transfer Surface Height
Bolsters improve patient comfort and stability when seated on table. Note that the design minimizes the bolsters at the front half of the seat in order to promote ease of transfer....
-
Conclusion
The study found that the majority of participants (5th percentile) could transfer independently to the platform at a height that was within one inch of the mean wheelchair or scooter seat...
-
Seating Accommodations
seats....
-
19 Inch Low Height
For example: Nineteen-inch pool lift seats are accessible: 1009.2.4 Seat Height....
-
5. PLAN INCLUSIVELY
OBJECTIVES: Consider everyone in your planning. Be familiar with the services required for people with disabilities, access, or functional needs....
-
§ 37.139 Plan contents
Each plan shall contain the following information:...
- Access Board: Sign Scoping
-
Requirement 6. Reinforced walls for grab bars.
that all premises within covered multifamily dwelling units contain reinforcements in bathroom walls to allow later installation of grab bars around toilet, tub, shower stall and shower seat...
- State of Texas Functional Needs Support Services Tool Kit
-
11B-233.3.1.2.6.5 Additional requirements.
Water closet seat height complying with Section 11B-809.10.7.4. 7. Electrical receptacles, switches and controls complying with Section 11B-809.12. 8....
-
DSA IR 11B-6 ACCESSIBILITY REVIEW OF MECHANICAL (HVAC) PROJECTS (revised 05/27/2021)
Revised 05/27/21 Issued 02/04/08 References: California Code of Regulations (CCR) Title 24 Part 2: California Building Code (CBC), Chapter 2 Definition of...
- Fire Safety and Disabilities Guide