Suggestions by Jean Tessmer As published in Concrete Technology Today, April 2001, Jean Tessmer, accessibility consultant for Space Options, suggested that ramp slopes be measured with...
Search Results "Ramp Rise"
Commonly Searched Documents
- 
    
  
  Suggestions by Jean Tessmer
  
- Freedom Resource Center for Independent Living, Inc. - Fargo, Jamestown, Wahpeton, ND. and Fergus Falls, MN
- 
    
  
  1.2.2
  1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements... 
- 
    
  
  11B-303.3 Beveled
  Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). ... 
- 
    
  
  6b.
  Is the change in level from the floor to the lift surface ramped or beveled? Yes _____ No _____... 
- 
    
  
  ACTIONS TAKEN BY CITY OF WAUKEGAN
  The City installed an interior ramp that was meant to provide access from the old city hall to the new city hall addition. ... 
- 
    
  
  Construction Specification Institute
  Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp... 
- 
    
  
  11B-108 Maintenance of accessible features
  It is not sufficient to provide features such as accessible routes, parking, elevators, ramps or signage if those features are not maintained in a manner that enables individuals with disabilities... 
- Walk-A-Sured Roll-On Anti-Slip Safety Coating System
- Walk-A-Sured Clear Anti-Slip Safety Coating System
- 
    
  
  i.
  "Suspicious Minds" Exhibit ramp leading to the exhibits; and See Standards § 4.8.5(3).... 
- 
    
  
  T402.4 Emergency Operation
  Power-operated ramps and bridgeplates shall be capable of manual operation in the event of a power failure.... 
- 
    
  
  Homemods.org
  ., grab bars, ramps), moving furnishings, changing where activities occur (e.g., sleeping on the first instead of second floor) and renovations (e.g., installing a roll-in shower).... 
- 
    
  
  R305 Detectable Warning Surfaces (Section-by-Section Analysis)
  At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space.... 
- 
    
  
  303.3 Beveled
  Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level ... 
- 
    
  
  Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
  Blind was a member of the advisory committee that recommended the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps... 
- 
    
  
  R302.6 Cross Slope
  Cross slope requirements are contained in R304.5.3 for curb ramps and blended transitions, and in R407.3 for ramps.... 
- 
    
  
  Slope [4.3.7]
  Where the running slope of an accessible route exceeds 5% it must be treated as a ramp or curb ramp. A maximum cross slope of 2% is recognized for drainage.... 
- 
    
  
  11B-405.9.2 Curb or barrier
  To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp.... 
- 
    
  
  907.5.2.3 Visible alarms
  Visible alarm notification appliances shall not be required in enclosed exit stairways, enclosed exit ramps, exterior exit stairs and exterior exit ramps. 3.... 
- 
    
  
  [F] 907.5.2.3 Visible alarms
  Visible alarm notification appliances shall not be required in enclosed exit stairways, enclosed exit ramps, exterior exit stairs and exterior exit ramps.... 
- 
    
  
  11B-405.9.2 Curb or barrier
  To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp.... 
- Inclusion Solutions BigBell™ Alert System
- Harmar CPL400P Portable Vertical Platform Lift
